Apply a small amount of the included grease to the right Crank Arm (20) and to a 19mm Wave Washer (66).
Slide a Crank Arm Spacer (55) and the 19mm Wave Washer (66) onto the right Crank Arm (20).
Identify the Right Roller Arm (59), which is
marked with a "Right" sticker, and orient it as shown.
Slide the Right Roller Arm (59) onto the right Crank Arm (20). Attach the Right Roller Arm with an M8 x 19mm Patch Screw (82), an Axle Cover (53), and an M8 x 25mm Washer (98); to avoid breaking the Axle Cover, do not over= tighten the Patch Screw.
Repeat this step for the Left Roller Arm (not shown).
. Identify the Right Pedal Bracket (64), which is marked with a "Right" sticker.
Apply a small amount of grease to the inside of the tube on the Right Roller Arm (59) and to the barrel of an M10 x 60mm Bolt (100).
Attach the Right Pedal Bracket (64) to the Right Roller Arm (59) with the M10 x 60mm Bolt (100), an M10 Washer (95), and an M10 Locknut (92). Do not overtighten the Locknut; the Right Pedal Bracket must pivot freely.
Repeat this step for the Left Pedal Bracket
(48).
Grease
98
53
59
92
48
\
100
Grease
59
7