JVC CA-MXGT700 manual Common Operations, Turning On or Off the Power, Setting the Clock

Common Operations Continued

English

Turning On or Off the Power

3 Press 4or ¢to adjust the minute, then press SET.

To turn on the unit, press

STANDBY/ON so that the STANDBY lamp goes off.

To turn off the unit (on standby), press

STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY

STANDBY/ON

STANDBY

STANDBY/ON

SET

To check the clock time

DISPLAY

Press DISPLAY while playing any source.

A little power is always consumed even while the unit is on standby.

• Each time you press the button, the source indication and the clock time alternate on the display.

To adjust the clock again

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –” soon, while the tuner preset stations (see page 13) will be erased in a few days.

Setting the Clock

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily Timer)

Canceled CLOCK ON TIME

(Recording Timer)

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:
1 Press CLOCK/TIMER.	/TIMER
	CLOCK

The hour digits start flashing on the display.

2 Press 4 or ¢ to adjust the hour, then press SET.

SET

The minute digits start flashing on the display.

•If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.

– 10 –