JVC CA-MXGT700 manual Using the Microphones, Singing Along-Karaoke

Page 26

English

Using the Microphones

You can enjoy singing along (Karaoke) and microphone mixing.

IMPORTANT:

Always set the MIC LEVEL to MIN when connecting or disconnecting the microphone.

When you do not use the microphone, keep the microphone unconnected.

If howling or squealing (feedback) occurs while using the

microphone, take the following actions to prevent these noises.

Adjust the MIC LEVEL and VOLUME controls.

Avoid pointing the microphone towards the speakers.

To apply an echo to your voice

Press ECHO on the remote control so that the echo () indicator lights up on the display.

Each time you press the button, the echo level changes as

follows:

ECHO 1 (

)

ECHO 2 (

)

 

ECHO OFF ( )

ECHO 2 applies stronger echo effect to your voice.

Microphone Mixing

When you use microphone with any playback source, follow the procedure below.

Singing Along—Karaoke

Vocal Masking

Vocal Masking reduces the lead vocal of the playing souce and allows you to replace it by singing into the microphone as the music plays.

• This function cannot be used for multiplex discs or tapes.

1 Turn MIC LEVEL to MIN.

2 Connect the microphone (not supplied) by plugging it into the MIC jack.

The karaoke indicator (

) lights up on the display.

3 Start playing the source—CD, tape or other connected component.

4 Press KARAOKE on the remote

KARAOKE

control repeatedly.

 

Each time you press the button, Vocal Masking turns on (V.MASK) and off (OFF).

1 Turn MIC LEVEL to MIN.

2 Connect the microphone (not supplied) by plugging it into the MIC jack.

3 Start playing the source—CD, tape or other connected component.

4 Turn MIC LEVEL and VOLUME controls as you sing into the microphone.

• By pressing REC START/STOP, you can record your singing along. (For more details, see page 19.)

To stop during recording, press

REC START/STOP again or 7.

To use microphone only

Without any background sound, you can use your microphone and record it.

V.MASK : Reduces the vocals.

OFF : Cancels Vocal Masking (normal stereo playback).

5 Turn MIC LEVEL and VOLUME controls as you sing into the microphone.

1

2

Connect the microphone.

Press CD 6, then 7.

No background sound will be heard.

When you finish singing, cancel the

CD

 

Karaoke function by pressing

 

KARAOKE.

 

• By pressing REC START/STOP, you

3 Turn MIC LEVEL and VOLUME

can record your singing along. (For

more details, see page 19.)

controls as you sing into the

To stop during recording, press REC START/STOP again

microphone.

or 7.

• By pressing REC START/STOP, you

If you use the following sources as the playing source

can record your singing. (For more

for Vocal Masking, you cannot get the satisfactory

details, see page 19.)

results

 

• Radio programs—a radio signal is not as reliable as the signals

To stop during recording, press

coming from a tape or CD.

REC START/STOP again or 7.

• Monaural sources.

 

Poorly dubbed tapes.

Sources recorded with duets, strong echo, a chorus, or only a few instruments.

21 –

Image 26
Contents CA-MXGT700 CA-MXG500 Page English Español Português Precaución el aparato debe estar bien ventilado Class Laser Product About This Manual PrecautionsIntroduction Contents Location of the Buttons and Controls Front PanelFront Panel Display windowRemote Control Remote ControlUnpacking Connecting AntennasGetting Started AM antenna Connecting SpeakersRelease the finger from the clamp To connect an outdoor AM antennaTo connect an analog component Connecting Other EquipmentFor CA-MXGT700 To remove the speaker grilles To cancel the display demonstration, press Adjusting the Voltage SelectorCanceling the Display Demonstration On the unit onlyOn the unit only Press CLOCK/TIMER Turning On or Off the PowerSetting the Clock Common OperationsTo turn down the volume level temporarily Setting the AM Tuner Interval SpacingAdjusting the Volume Selecting the SourcesSurround modes Reinforcing the Bass SoundSelecting the Sound Modes SEA Sound Effect Amplifier modesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to the RadioLoading CDs Playing Back CDsPlaying Back CDs-All Disc and One Disc Basic CD Operations Programing the Playing Order of the Tracks --Program Play Press one of the disc number Buttons CD1, CD2, and CD3 toProhibiting Disc Ejection--Tray Lock Playing at Random--Random PlayRepeating Tracks or CDs--Repeat Play Press one of the disc number Buttons CD1, CD2, and CD3Press Eject 0 for the deck you want to use Playing Back TapesPlaying Back a Tape Close the cassette holder gentlyPress REC START/STOP RecordingRecording a Tape on Deck B On the unit only Press Tape 3, then Dubbing TapesCD Synchronized Recording Press DubbingUsing the Microphones Singing Along-KaraokeUsing the Timers Using Daily TimerUsing Recording Timer Press CLOCK/TIMER againOn the remote control only Press Sleep Using Sleep TimerTimer Priority Handling discs MaintenanceCleaning the unit Handling cassette tapesTroubleshooting SymptomSpecifications CA-MXG500 Important for mains AC line SP-MXG500 Connection Conexión 0205NSMMDWSAM