JVC CA-MXGT700 manual Maintenance, Cleaning the unit, Handling discs, Handling cassette tapes

Page 30

English

Maintenance

To get the best performance of the unit, keep your discs, tapes, and mechanism clean.

Cleaning the unit

•Stains on the unit

Should be wiped off with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in water-diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

•Avoid the following since they may cause damage to the unit.

-DO NOT wipe it with a hard cloth.

-DO NOT wipe it strong.

-DO NOT wipe it with thinner or benzine.

-DO NOT apply any volatile substance such as insecticides to it.

-DO NOT allow any rubber or plastic to remain in contact with it for a long time.

Handling discs

• Remove the disc from its case by holding it at the edge while pressing the center hole lightly.

• Do not touch the shiny surface of the disc, or bend the disc.

• Put the disc back in its case after use to prevent warping.

• Be careful not to scratch the surface of the disc when placing it back in its case.

• Avoid exposure to direct sunlight, temperature extremes, and moisture.

Handling cassette tapes

• If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.

• If the tape is loose, it may get stretched, cut, or caught in the cassette.

•Be careful not to touch the tape surface.

•Avoid the following places to store the tape:

— In dusty places

— In direct sunlight or heat

—In moist areas

—Near a magnet

To clean the disc

Wipe the disc with a soft cloth in a straight line from center to edge.

DO NOT use any solvent—such as conventional record cleaner, spray, thinner, or benzine—to clean the disc.

– 25 –

Image 30

Contents CA-MXGT700 CA-MXG500 Page English Español Português Precaución el aparato debe estar bien ventilado Class Laser Product Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Display windowRemote Control Remote ControlConnecting Antennas Getting StartedUnpacking AM antenna Connecting SpeakersRelease the finger from the clamp To connect an outdoor AM antennaConnecting Other Equipment For CA-MXGT700 To remove the speaker grillesTo connect an analog component To cancel the display demonstration, press Adjusting the Voltage SelectorCanceling the Display Demonstration On the unit onlyOn the unit only Press CLOCK/TIMER Turning On or Off the PowerSetting the Clock Common OperationsTo turn down the volume level temporarily Setting the AM Tuner Interval SpacingAdjusting the Volume Selecting the SourcesSurround modes Reinforcing the Bass SoundSelecting the Sound Modes SEA Sound Effect Amplifier modesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to the RadioPlaying Back CDs Playing Back CDs-All Disc and One DiscLoading CDs Basic CD Operations Programing the Playing Order of the Tracks --Program Play Press one of the disc number Buttons CD1, CD2, and CD3 toProhibiting Disc Ejection--Tray Lock Playing at Random--Random PlayRepeating Tracks or CDs--Repeat Play Press one of the disc number Buttons CD1, CD2, and CD3Press Eject 0 for the deck you want to use Playing Back TapesPlaying Back a Tape Close the cassette holder gentlyRecording Recording a Tape on Deck BPress REC START/STOP On the unit only Press Tape 3, then Dubbing TapesCD Synchronized Recording Press DubbingUsing the Microphones Singing Along-KaraokeUsing the Timers Using Daily TimerUsing Recording Timer Press CLOCK/TIMER againUsing Sleep Timer Timer PriorityOn the remote control only Press Sleep Handling discs MaintenanceCleaning the unit Handling cassette tapesTroubleshooting SymptomSpecifications CA-MXG500 Important for mains AC line SP-MXG500 Connection Conexión 0205NSMMDWSAM