JVC CA-MXGT700 manual Troubleshooting, Symptom

Page 31

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

English

Symptom

Unable to cancel the display demonstration.

No sound is heard.

Hard to listen to broadcasts because of noise.

The disc sound is discontinuous.

The carrousel does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Stereo effect is lost.

Operations are disabled.

Unable to operate the unit from the remote control.

Cause

Other buttons are pressed to cancel the display demonstration.

Connections are incorrect or loose.

Antennas are disconnected.

The AM loop antenna is too close to the unit.

The FM antenna is not properly extended and positioned.

The disc is scratched or dirty.

The AC power cord is not plugged in.

The carrousel is locked.

The disc is placed upside down.

Power supply from the AC power cord has been cut off while the tape was running.

Small tabs on the back of the cassette are removed.

Vocal Masking is activated.

The built-in microprocessor may malfunction due to external electrical interference.

The path between the remote control and the remote sensor on the unit is blocked.

The batteries are exhausted.

Action

Press CANCEL/DEMO on the unit. (See page 9.)

Check all connections and make corrections. (See pages 6 to 8.)

Reconnect the antennas correctly and securely.

Change the position and direction of the AM loop antenna.

Extend the FM antenna at the best position.

Clean or replace the disc. (See page 25.)

Plug the AC power cord.

Unlock the carrousel. (See page 17.)

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Cancel the Vocal Masking. (See page 21.)

Unplug the AC power cord and then plug it back in.

Remove the obstruction.

Replace the batteries.

– 26 –

Image 31
Contents CA-MXGT700 CA-MXG500 Page English Español Português Precaución el aparato debe estar bien ventilado Class Laser Product Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsDisplay window Front PanelRemote Control Remote ControlGetting Started Connecting AntennasUnpacking To connect an outdoor AM antenna Connecting SpeakersRelease the finger from the clamp AM antennaFor CA-MXGT700 To remove the speaker grilles Connecting Other EquipmentTo connect an analog component On the unit only Adjusting the Voltage SelectorCanceling the Display Demonstration To cancel the display demonstration, pressCommon Operations Turning On or Off the PowerSetting the Clock On the unit only Press CLOCK/TIMERSelecting the Sources Setting the AM Tuner Interval SpacingAdjusting the Volume To turn down the volume level temporarilySEA Sound Effect Amplifier modes Reinforcing the Bass SoundSelecting the Sound Modes Surround modesListening to the Radio Tuning in a StationPresetting Stations Tuning in a Preset StationPlaying Back CDs-All Disc and One Disc Playing Back CDsLoading CDs Basic CD Operations Press one of the disc number Buttons CD1, CD2, and CD3 to Programing the Playing Order of the Tracks --Program PlayPress one of the disc number Buttons CD1, CD2, and CD3 Playing at Random--Random PlayRepeating Tracks or CDs--Repeat Play Prohibiting Disc Ejection--Tray LockClose the cassette holder gently Playing Back TapesPlaying Back a Tape Press Eject 0 for the deck you want to useRecording a Tape on Deck B RecordingPress REC START/STOP Press Dubbing Dubbing TapesCD Synchronized Recording On the unit only Press Tape 3, thenSinging Along-Karaoke Using the MicrophonesUsing Daily Timer Using the TimersPress CLOCK/TIMER again Using Recording TimerTimer Priority Using Sleep TimerOn the remote control only Press Sleep Handling cassette tapes MaintenanceCleaning the unit Handling discsSymptom TroubleshootingSpecifications CA-MXG500 Important for mains AC line SP-MXG500 Connection Conexión 0205NSMMDWSAM