Step 5 Assemble the Rocker Arms; Moving Arm Pivot Covers
Parts: Hardware Bag #3 (2, Wave Washers, 2 Large Flat Washers) (2, Flat Washers)
(2, M10 x 20mm Silver Hex Head Bolts) (4, 8mm Black Phillips Head Screws)
Tools: 17mm Socket Wrench, Phillips Screwdriver
Slide one large flat washer (4) and one wave washer (5) onto the user right pivot shaft (F). Slide the washers fully over the pivot shaft until seated against the
Locate the user right rocker arm assembly (H) marked with an R. 
With the top handgrip facing the front of the units slide the right 
rocker arm assembly onto the user right pivot shaft until seated 
against the washers.
Secure the rocker arm assembly to the pivot shaft using one flat washer (6) and one M10 x 20mm Silver Hex Head Bolt (7). Tighten the bolt securely. Repeat the procedure for the left rocker arm assembly.
Attach the right side upper pivot covers (J) labeled with the letter "R" over the upright shaft. Snap the covers together and use two 8mm black Phillips head screws (8) to attach the covers. Repeat for left side.
CAUTION: There is a different left and right cover.
13