Assembly
Step 2
A)Insert Left Handlebar into the opening at the top of the left side on the Main Frame. Secure to the Pivot Arm using a Small Washer and a M8*45mm Hex Bolt.
B)Slide two of the Cover Plates over the holes for the Short Screws.
C)Attach the Small Cover and secure in place using two Short Screws.
B)Slide a Grommet down the Left Handlebar and snap it onto the Main Frame. Note: Make sure the Grommet is facing down as shown.
D)Repeat A, B, and C to complete the right side.
Figure 2
Left Handlebar
Grommet
M8*45mm Hex Bolt
Small Cover
Main Frame
Small Washer
Short Screw
6