24 | Assembling and Maintaining the UBK 615 Upright Exercise Bike |
Installing the Upright Support and Cables
DANGER Do not attempt to connect electrical power until all assembly procedures are complete and the console is properly installed.
Before you begin this procedure, retrieve the cables for the console that you plan to install on this exercise bike, or for any Cardio Theater® equipment that you plan to install on the console.
Note: You will need the help of another person to complete this procedure.
To install the upright support and prepare the cables for connection to the console:
1.Remove the wire tie holding the base unit data cable in place inside the upright support channel.
2.Proceed according to whether or not you are installing Cardio Theater equipment on the console.
If ... | Then ... |
You are not installing Cardio Theater | Skip to step 5. |
equipment on the console |
|
You are installing Cardio Theater equipment | Continue with |
on the console | step 3. |
3.Feed the lower ends of the following cables through the opening just above the front stabilizer:
Television cable
Power cable
4.Using the wire tie you removed in step 1, bind together the upper ends of all cables.
Note: A fish tape can be helpful in the following step.
5.Place the upright support on the floor with its lower end next to the body assembly. Thread the cable or cables upward through the support, then use the wire tie to secure the upper connectors of the cables at the top of the support.
Note: In the following step, do not remove the extra serial number label from its backing.
6.Remove the extra serial number label from the upright support channel on the body assembly. Set the label aside; you will be attaching it later in the installation.