34 | Assembling and Maintaining the UBK 615 Upright Exercise Bike |
4.Route the flat, black base unit data cable to the left of the mounting bracket and about three-quarters of the way up the left side of the console, as shown in the following figure. Attach the base unit data cable to the eight-conductor modular jack labeled LOWER BOARD CONNECTION.
Figure 15: Routing the data and heart rate cables
5.Attach the twisted, red-and-black heart rate sensor cable to the four-pin connector on the heart rate circuit board at the lower right corner of the console.
Note: The connectors can fit together in only one way. There may also be a 10-pin connector labeled HEART RATE on the console, but it is not compatible with this equipment.
Important: If you are installing a Cardio Theater screen or receiver, complete the Cardio Theater installation before you reattach the console’s rear cover.
6.Insert four ¹₄-inch x ³₄-inch buttonhead screws through the screw holes in the tabs on the mounting bracket and into the screw anchors on the console. Tighten the screws completely using a ⁵₃₂-inch hex wrench.
