Diagram 16
Location of magnet and reed switch.
Resistance cylinder
Base column support
Left stair arm
Magnet
Reed switch
Gap 1/8" to 1/4"
(.3 to .6 centimeters)
R
USA
10.Check Operation of Electronics. (Diagram 16) Make sure that the spacing between the magnet on the left stair arm and the reed switch on the rear short column is correct. If the spacing is incorrect, the electronic console display will not operate properly. The distance between the magnet and the reed switch should be about 1/8 inch (.3 centimeters). If the spacing is not correct, adjust the spacing by moving the reed switch in or out of the column with your fingers.
11.Set the Resistance. Adjust the stair arm resistance by turning the top of the resistance cylinder until the triangle on the resistance cylinder points to the “2” on the adjustment knob. Do the same for the other stair arm. Make sure that the resistance on both stair arms is at the same setting.
Diagram 17 |
|
|
Align stair arms with label (718e only). |
|
|
Rope |
|
|
Precor label red box | USA | USA |
| ||
Stair arm footpad |
|
|
Rear crossbar |
|
|
12.Install
a.Feed the rope up through the right stair arm mount. (Determine right and left while standing behind the rear crossbar and facing toward the electronic console.)
b.Move both stair arms so that the top of the stair arms line up with the red box located on the Precor label. See Diagram 17. Have an assistant hold the stair arms in place while you route the rope through the pulley.
Note: It may be easier to install the guide rope if the climber is placed on its right hand side on the floor. This will expose the underside of the stair arms and provide easier accessibility.
Page 14