9.Attach the Rear Upright Cover (24) to the Upright
(5) with four M4 x 16mm Screws (93).
Meijer.com
9
93
5
24
10. Attach the Front Upright Cover (25) around the |
| |
10 | ||
Upright (5) by pressing the tabs on the Front | ||
| ||
Upright Cover into the Rear Upright Cover (24). |
|
25
5
24
11.Identify the Short Pedal Arm Axles (115) and the Long Pedal Axles (not shown).
Apply a small amount of grease to a Short Pedal Arm Axle (115) and to an M8 x 23mm x 1.5mm Washer (126).
Next, tighten an M8 x 16mm Screw (102) and an M8 x 23mm x 1.5mm Washer (126) a few turns into one end of the Short Pedal Arm Axle (115).
Orient a Pedal Arm (12) as shown. While a sec- ond person holds the front end of the Right Pivot Arm (51) inside the bracket on the Pedal Arm, insert the Short Pedal Arm Axle (115) through both parts.
Tighten another M8 x 16mm Screw (102) and an M8 x 23mm x 1.5mm Washer (126) a few turns into the Short Pedal Arm Axle (115). Then, tighten both Screws at the same time.
Repeat this step on the other side of the elliptical.
11
102 126 Grease
115
12
51
126
102
10