Meijer.com
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra parts may be included.
M8 Split Washer | M8 x 23mm | M10 Split | Wave Washer | M8 Locknut | |
x 1.5mm Washer | Washer | ||||
|
|
|
|
M4 x 16mm | M4 x 25mm | M6 x 12mm | M8 x 16mm |
Screw | Screw | ||
|
| Screw | Screw |
M8 x 45mm Bolt | M8 x 50mm Screw |
|
M10 x 120mm Screw
5