Press the Home button to return to the default menu (see HOW TO CHANGE CONSOLE SETTINGS on page 22 to set the default menu). If necessary, press the Home button again.
When a wireless iFit Live module is connected, the wire- less symbol at the top of the display will show the strength of your wireless signal.
Four arcs indicate full signal strength.
To exit the manual mode or a workout, press the Home button. If necessary, press the Home button again.
Change the volume level of the console by pressing the Volume increase and decrease buttons.
5. Measure your heart rate if desired.
If there are | Contacts |
sheets of plastic | |
on the metal |
|
contacts on the |
|
handgrip heart |
|
rate monitor, |
|
remove the |
|
plastic. To mea- |
|
sure your heart |
|
rate, hold the |
|
handgrip heart |
|
rate monitor with your palms resting against the contacts. Avoid moving your hands or gripping the contacts tightly.
Meijer.com
When your pulse is detected, a heart symbol in the calorie display will flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, hold the contacts for at least 15 seconds.
If the display does not show your heart rate, make sure that your hands are positioned as described. Be careful not to move your hands excessively or to squeeze the contacts tightly. For optimal perfor- mance, clean the contacts using a soft cloth; never use alcohol, abrasives, or chemicals to clean the contacts.
6. When you are finished exercising, the console will turn off automatically.
If the pedals do not move for several seconds, a tone will sound, the console will pause, and the time will flash in the display. To resume your work- out, simply resume pedaling.
If the pedals do not move for several minutes and the buttons are not pressed, the console will turn off and the display will be reset.
19