ProForm PMTL39708.0 user manual

14. Partially tighten four M8 x 25mm Bolts (6) with	14
four M8 Star Washers (10) into the Uprights (73,
78) and the Handrails (89, 90). Then, tighten
all four Handrail Bolts.
See steps 5, 8, and 10. Tighten the four M10 x	89
96mm Bolts (5) and the four 1/4" x 3/4" Bolts
(98).		6
	6
		10				6
		73	90
						10
				6	10
					78
15. Press the Latch Insert (70) into the Left Upright	15
(73). If necessary, tap on the Latch Insert with a
rubber mallet.		Knob
Locate the Latch Pin Assembly (72). Remove			70
the knob from the pin. Make sure that the collar
and the spring are on the pin. Next, insert the				Spring
pin into the Latch Insert (70), and tighten the					Collar
knob back onto the pin.
Set the Dumbbells (not shown) in the Dumbbell						Pin
Rack (100), with the heaviest dumbbells in the		73		72
center of the Dumbbell Rack.					100

16.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see pages 22 and 23).

12