ProForm PMTL39708.0 user manual Cuit breaker to the off position when

Page 4

	19. Use the included dumbbells only as de-	23. Never insert any object into any opening on
	scribed in this manual. Properly store the	the treadmill.
	dumbbells in the dumbbell rack when you are	24. Inspect and properly tighten all parts of the
	not using them. If the dumbbells are improp-	24. Inspect and properly tighten all parts of the
	erly stored, they may fall off the rack, causing	treadmill regularly.
	the user to trip.	25. DANGER: Always unplug the power
	20. Never leave the treadmill unattended while it	cord immediately after use, before cleaning the
	is running. Always remove the key, unplug	treadmill, and before performing the mainte-
	the power cord, and switch the reset/off cir-	nance and adjustment procedures described in
	cuit breaker to the off position when the	this manual. Never remove the motor hood un-
	treadmill is not in use. (See the drawing on	less instructed to do so by an authorized ser-
	page 5 for the location of the circuit breaker.)	vice representative. Servicing other than the
	21. Do not attempt to raise, lower, or move the	procedures in this manual should be performed
	21. Do not attempt to raise, lower, or move the	by an authorized service representative only.
	treadmill until it is properly assembled. (See	by an authorized service representative only.
	ASSEMBLY on page 6, and HOW TO FOLD	26. This treadmill is intended for in-home use
	AND MOVE THE TREADMILL on page 19.)	only. Do not use this treadmill in a commer-
	You must be able to safely lift 45 lbs. (20 kg)	cial, rental, or institutional setting.
	to raise, lower, or move the treadmill.

22. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. PMTL39708.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Cuit breaker to the off position when By an authorized service representative onlyTreadmill until it is properly assembled. See Before YOU Begin Assembly Make sure that the power cord is unplugged Do not fully fold the Frame yetTouch the Upright do not fully tighten Bolts yet Page Tighten the Bolts yet Be Damaged When the Power is Nected PROPERLY, the Console MAYPage HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleMeasure your heart rate if desired HOW to USE a Preset Workout Information Mode HOW to USE the DumbbellsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power does not turn onProblem The power turns off during use Compatible with GFCI-equipped outletsProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part LIST-Model No. PMTL39708.0 Key No. Qty Description107 Filter Wire Userʼs Manual Exploded Drawing A-Model No. PMTL39708.0 R0509A Exploded Drawing B-Model No. PMTL39708.0 R0509A Exploded Drawing C-Model No. PMTL39708.0 Exploded Drawing D-Model No. PMTL39708.0 R0509A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT