2.With the help of a second person, carefully tip the treadmill onto its right side as shown.
Insert the other Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg. Next, insert two Base Leg Bolts (65) into the top of the Extension Leg, and firmly tighten the Base Leg Bolts into the Extension Leg Nuts.
Attach two Base Pads (82) to the base of the Uprights (84) with two 3/4" Tek Screws (22).
With the help of a second person, carefully raise the treadmill so that all four Base Pads (82) are on the floor and the Frame (58) is in a vertical position (see the drawing in step 4).
3.Identify the Storage Latch (29). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over hole 1 and that the Latch Knob (97) is locked into hole 1. Pull on the sleeve to make sure that it is locked into place.
2 |
|
84 |
|
| 65 |
82 |
|
82 |
|
22 |
|
| 58 |
67 | 89 |
3 |
|
| 97 |
Hole 1
Tube
29
Sleeve
4.Orient the Latch Assembly (29) so that the large barrel and the Latch Knob (97) are positioned as shown. Attach the lower end of the Latch Assembly to the bracket on the Upright (84) with the Lower Latch Shock Bolt (39) and a Latch Shock Nut (30).
Then, attach the upper end of the Latch Assembly (29) to the bracket on the Frame (58) with the Upper Latch Shock Bolt (50) and a Latch Shock Nut (30). Note: It may be neces- sary to move the Frame back and forth to align the Latch Assembly with the bracket.
458
30 50
97
29
Large 
Barrel 
84
30 
39
7