5.Lower the Frame (not shown) (see HOW TO LOWER THE TREADMILL FOR USE on page 20).
Have a second person hold the Handrail (20) near the Uprights (84). Insert the Wire Harness (77) into the hole in the bottom of the Handrail and out of the top as shown.
Next, set the Handrail (20) on the Uprights (84).
Do not let the Wire Harness (77) fall into the right Upright.
Attach the Handrail (20) with four Handrail Bolts
(64) and four Star Washers (8); start all four
Handrail Bolts and then firmly tighten them.
6.While a second person holds the console as- sembly near the Handrail (20), attach the ground wire to the indicated hole in the Handrail with a Ground Screw (33).
5 |
| |
64 |
| |
8 |
| |
64 | 20 | |
8 | ||
| ||
| 77 | |
84 |
| |
| 84 | |
6 |
| |
Console |
| |
Assembly |
| |
Ground |
| |
Wire |
| |
33 |
| |
Hole |
| |
20 |
|
7. While the second person continues to hold the | 7 |
|
|
console assembly, locate the wire harness un- |
|
| |
|
|
| |
derneath the console assembly. |
|
|
|
Connect the wire harness from the console as- |
|
|
|
sembly to the Wire Harness (77). See the inset |
|
|
|
drawing. The connectors should slide to- |
| Wire Harness | 77 |
gether easily and snap into place. If the con- |
|
|
|
nectors do not slide together easily and snap |
|
|
|
into place, turn one connector and then try |
|
|
|
again. IF THE CONNECTORS ARE NOT CON- | Console | 77 |
|
NECTED PROPERLY, THE CONSOLE MAY |
| ||
Assembly |
|
| |
BE DAMAGED WHEN THE POWER IS |
|
| |
|
|
| |
TURNED ON. Then, insert the connectors |
|
|
|
downward into the Handrail (20). |
|
|
|
|
| 20 |
|
| 8 |
|
|