ProForm PFTL69501 Unplug the Power, Cord, Symptom The walking belt slows when walked on

4. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY

a. Remove the key from the console and			UNPLUG THE POWER
CORD.	Remove the screws from the hood. Carefully remove the
hood. Locate the Reed Switch (26) and the Magnet (107) on the
left side of the Pulley (12). Turn the Pulley until the Magnet is
aligned with the Reed Switch.		Make sure that the gap between
the Magnet and the Reed Switch is about 1/8”.			If necessary,

loosen the Reed Switch Screw (109) and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading.

5. SYMPTOM: The walking belt slows when walked on

1/8”	12
109
26	107
Top
View

a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b.If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove

the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts counterclockwise,

1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt cen- tered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tight- ened

c.If the walking belt still slows when walked on, please call our Customer Service Department, toll-free.

b

3”–4”

Rear Roller Adjustment Bolts

6. SYMPTOM: The walking belt is off-center
a. If the walking belt is off-center, first remove the key and		UN-
PLUG THE POWER CORD	. If the walking belt has shifted to

the left, use the allen wrench to turn the left rear roller bolt clock- wise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on, first remove the key and

UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

21