ASSEMBLY
Assembly requires two persons. | Set the treadmill in a cleared area and remove all packing materials; | do not | |
dispose of the packing materials until assembly is completed. | Note: The underside of the treadmill walking |
|
belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | |
adjustable wrench | . |
|
1.Identify the Right Upright (103), which has the Pulse Wire (121) inside of it. Do not remove the rubber bands from the Pulse Wire until the Pulse Wire has
been connected.
Have a second person hold the Console Base (64) near the Right Upright (103) as shown. Feed the Wire Harness (90) into the indicated hole near the upper end of the right Upright and out of the hole near the lower end of the Right Upright.
Connect the Wire Harness (90) to the Base Wire Harness |
| |
(126). If the connectors do not fit together easily | ,ro- | |
tate them and then connect them. | Insert the connectors |
into the Right Upright (103). Be careful not to damage the Wire Harness during steps 1 through 5.
2.Have a second person hold the Right Upright (103) and the Console Base (not shown) in a vertical position. Hold the Right Upright against the Base (118) as shown.
Hand tighten two Upright Bolts (84) with Washers (125) and Star Washers (89) into the Right Upright and the Base; do not tighten the Upright Bolts yet. Be careful
not to pinch the Wire Harness (not shown) inside of the Right Upright.
Attach the Left Upright (not shown) as described above. Note: There are no wires in the Left Upright.
3.Hold the Pulse Bar (101) near the Right Upright (103). Disconnect the ends of the Pulse Wire (121) in the Right Upright from each other. Connect the wire in the Pulse
Bar to the Pulse Wire. If the connectors do not fit to-
gether easily ,rotate them and then connect them.
Orient the Pulse Bar (101) so that the small screws in |
| |
the Pulse Bar are on the side shown by the arrow. Slide |
| |
the |
| |
end of the Pulse Bar into the Right Upright (103). | Hand | |
tighten a Pulse Bar Bolt (104) with a Washer (125) into |
| |
the Right Upright and the Pulse Bar. | Do not tighten the | |
Pulse Bar Bolt yet. |
|
|
Hand tighten the other Pulse Bar Bolt and Washer into the Left Upright and the Pulse Bar (not shown). Note: There is not a wire in the left end of the Pulse Bar.
and |
|
1 | 90 |
| |
64 | Hole |
| |
| 121 |
| 103 |
126 |
|
90 | 118 |
| |
Hole |
|
2 |
|
103 |
|
125 |
|
| 118 |
84 | 89 |
| |
3 |
|
101 |
|
129 | 103 |
| |
121 | 125 |
| 104 |
6