JVC RX-5040B, RX-6042S, RX-6040B manual Tuning in to Stations Manually

English

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in to Stations Manually	Remote	Using Preset Tuning
	NOT

1Select the band (FM or AM).

•For RX-6040B/RX-6042S: Press FM or AM.

•For RX-5040B/RX-5042S/RX-5045B: Press FM/AM. Each time you press the button, the band alternates between FM and AM.

AUTO MUTING

VOLUME

TUNED STEREO AUTO MUTING

VOLUME

The last received station of the selected band is tuned in.

2Press FM/AM TUNING 5 or ∞ repeatedly until you find the frequency you want.

•Pressing FM/AM TUNING 5 increases the frequency.

•Pressing FM/AM TUNING ∞ decreases the frequency.

TUNED STEREO AUTO MUTING

VOLUME

Notes:

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

•When an FM stereo program is received, the STEREO indicator also lights up.

•When you hold and then release the button in step 2, the frequency keeps changing until a station is tuned in.

Once a station is assigned to a channel number, the station can be quickly tuned in. You can preset up to 30 FM and 15 AM stations.

To store the preset stations	Remote
Before you start, remember...	NOT

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

1Tune in the station you want to preset (see “Tuning in to Stations Manually”).

•If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 17.

2Press MEMORY.

TUNED STEREO AUTO MUTING

VOLUME

The channel number position starts flashing on the display for about 5 seconds.

3Press FM/AM PRESET 5 or ∞ to select a channel number while the channel number position is flashing.

TUNED STEREO AUTO MUTING

VOLUME

4 Press MEMORY again while the selected channel number is flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

5Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

16