JVC RX-6042S, RX-6040B, RX-5040B manual Press in Multi JOG Push SET

Adjusting Sound

You can make sound adjustment to your preference after completing basic settings.

English

Basic Adjustment Items

On the following pages, you can adjust the following items:

•You can adjust only the items applicable to the current sound mode.

Items	To do	See page
DEQ 63HZ	Adjust equalizer pattern at 63 Hz.		24
DEQ250HZ	Adjust equalizer pattern at 250 Hz.		24
DEQ 1KHZ	Adjust equalizer pattern at 1 kHz.		24
DEQ 4KHZ	Adjust equalizer pattern at 4 kHz.		24
DEQ16KHZ	Adjust equalizer pattern at 16 kHz.		24
SUBWFR LEVEL	Adjust the subwoofer output level.		24
FRONT L LEVEL	Adjust the left front speaker output
	level.		24
FRONT R LEVEL	Adjust the right front speaker output
	level.		24
CENTER LEVEL	Adjust the center speaker output
	level.		24
SURR L LEVEL	Adjust the left surround speaker
	output level.		24
SURR R LEVEL	Adjust the right surround speaker
	output level.		24
EFFECT*1	Adjust the effect level.		24
CENTER TONE*2	Make the center tone soft or sharp.		24
PANORAMA CTRL*3 Add “wraparound” sound effect with
	side-wall image.		24

Basic Procedure	NOT
	Remote

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Ex. When adjusting the subwoofer level to “–3”.

1 Press ADJUST.

The last selected item appears on the display.

2Turn MULTI JOG until an item you want appears on the display.

•In this example, select “SUBWFR LEVEL.” For available items, see the list “Basic Adjustment Items.”

		3	Press in MULTI JOG (PUSH SET).
Notes:			The current setting (or level) for the selected item appears on the
*1	Adjustable when one of the DAP modes or Mono Film (see pages		display.
	28 and 29) is in use.
*2	This setting is only for RX-6040B/RX-6042S.
*3	Adjustable when Pro Logic II Music is in use.
		4	Turn MULTI JOG to select a setting you want or
			to make an adjustment as you like.

5 Press in MULTI JOG (PUSH SET).

6 Repeat steps 2 to 5 to set other items if necessary.

7 Press EXIT.

The source indication resumes on the display.

23