JVC RX-6500VBK manual Troubleshooting, Problem Possible Cause Solution

Page 36

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.

 

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

 

 

 

The display does not light up.

The power cord is not plugged in.

Plug the power cord into an AC outlet.

 

 

 

 

 

 

No sound from speakers.

Speaker signal cables are not connected.

Check speaker wiring and reconnect if

 

 

 

necessary.

 

 

 

 

 

 

 

The SPEAKERS 1 and 2 buttons are not

Press SPEAKERS 1 and 2 correctly.

 

 

set correctly.

 

 

 

 

 

 

 

 

 

An incorrect source is selected.

Select the correct source.

 

 

 

 

 

 

 

Muting is activated.

Press MUTING to cancel the mute.

 

 

 

 

 

 

Sound from one speaker only.

Speaker signal cables are not connected

Check speaker wiring and reconnect if

 

 

properly.

necessary.

 

 

 

 

 

 

 

The balance is set to one extreme.

Adjust the balance properly (see page 11).

 

 

 

 

 

 

Continuous hiss or buzzing during FM

Incoming signal is too weak.

Connect an outdoor FM antenna or contact

 

reception.

 

your dealer.

 

 

 

 

 

 

 

The station is too far away.

Select a new station.

 

 

 

 

 

 

 

An incorrect antenna is used.

Check with your dealer to be sure you have

 

 

 

the correct antenna.

 

 

 

 

 

 

 

Antennas are not connected properly.

Check connections.

 

 

 

 

 

 

Occasional cracking noise during FM

Ignition noise from automobiles.

Move the antenna farther from automobile

 

reception.

 

traffic.

 

 

 

 

 

 

Howling during record playing.

Your turntable is too close to speakers.

Move speakers away from the turntable.

 

 

 

 

 

 

“OVERLOAD” starts flashing on the

Speakers are overloaded because of high

1. Press POWER on the front panel to turn off

 

display.

volume.

the receiver.

 

 

 

2. Stop the playback source.

 

 

 

3. Turn on the receiver again, and adjust the

 

 

 

volume.

 

 

 

 

 

 

 

Speakers are overloaded because of short

Press POWER on the front panel to turn off

 

 

circuit of speaker terminals.

the receiver, check the speaker wiring, then

 

 

 

press it again to turn on the receiver again.

 

 

 

If “OVERLOAD” does not disappear though

 

 

 

speaker wiring is not short-circuited, consult

 

 

 

your dealer.

 

 

 

 

 

Remote control does not work.

There is an obstruction in front of the

Remove the obstruction.

 

 

remote sensor on the receiver.

 

 

 

 

 

 

 

 

Batteries are weak.

Replace batteries.

 

 

 

 

 

English

33

Page 35 Page 37
Image 36
Page 35 Page 37
Contents RX-6500VBK Errata Sheet For U.S.A Table of Contents Front Panel Remote Control Parts Identification@ Û # Ü To use the Multi Cursor buttons w on the front panelBefore Installation Connecting the FM and AM AntennasChecking the Supplied Accessories Getting StartedConnecting the Speakers Basic connecting procedureConnecting the front speakers Connecting the rear and center speakersConnecting Audio/Video Components Connecting the subwoofer speakerAnalog connections Audio component connectionsVideo component connections DVD playerVCR If your audio components have an AV Compu Link terminalConnecting the Power Cord Putting Batteries in the Remote ControlOn the back of the remote control, remove Battery coverTurning the Power On and Off Standby From the remote controlSignal and speaker indicators on the display Basic OperationsSelecting the Front Speakers Muting the SoundAdjusting the Subwoofer Output Level Attenuating the Input SignalAdjusting the Tone Reinforcing the BassBasic Settings Adjusting the Front Speaker Output BalanceRecording a Source Changing the Source NameSetting the Speakers for the DSP Modes Press Setting repeatedly untilRear Delay appears on Display Front SPK Front SpeakerLFE ATT Low Frequency Effect Attenuator appears on Display Select the low frequency effect Attenuator levelRange COMP. Dynamic Range Compression appears on Display Select the appropriate item about Compression levelDigital Input Digital in Terminal Setting Press Multi Cursor @/ #to select an appropriate settingSelecting the Analog or Digital Input Mode On the front panelSetting the Subwoofer Information Storing the Basic Settings Adjustments One Touch OperationUsing the Sleep Timer Tuning in Stations Manually Using Preset TuningReceiving Radio Broadcasts Select a preset channel station Press 10 keys to select a preset channel numberTo tune in a preset station When an FM stereo broadcast is hard to receive or noisyUsing the DSP Modes 3D-PHONIC modesDAP modes Headphones mode Surround modesDolby Surround Dolby Digital and Dolby Pro Logic DTS Digital SurroundAvailable DSP Modes According to the Speaker Arrangement FrontAdjusting the 3D-PHONIC Modes Adjusting the DAP Modes Headphones modeAdjusting the Surround Modes Appropriate Surround mode Press Test again to stop the test Test tonePress Surround to activete an Press Test to check the speaker output balancePress Test again to stop the test tone Press Effect to select an effectActivating the DSP Modes Press Surround so thatLamp next to the button lights up Select and play a sound sourceCompu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverSame time Synchronized RecordingAV Compu Link Remote Control System CASE1CASE2 CASE3Automatic Selection of TV’s Input Mode Automatic Power On/OffOne-Touch Video Play One-Touch DVD PlayOperating JVC’s Audio/Video Components Sound control section AmplifierTurntable CD playerCD player-changer Cassette deckMD recorder REC PauseRelease TV Power Try to operate your TV by pressing TV PowerIf there are more than one code listed for your brand of TV Operating Other Manufacturers’ Video EquipmentRelease VCR Power Try to operate your VCR by pressing VCR PowerRelease CATV/SAT Power Manufacturer CodesTroubleshooting Problem Possible Cause SolutionSpecifications Per channel, min. RMS, driven into 8 ΩHz to 20 kHz with no more than 0.8% total Harmonic distortionFM tuner IHF AM tunerGeneral 781 954 650 Valley Road Wayne, NJ1099 Limited Warranty AUDIO-2 1299HIMMDWJEIN

RX-6500VBK specifications

The JVC RX-6500VBK is a versatile and powerful audio receiver designed to enhance your home theater experience. This model stands out due to its impressive combination of features, technology, and connectivity options, catering to both casual listeners and audiophiles alike.

At the core of the RX-6500VBK is its robust amplification system, which delivers an impressive power output of 100 watts per channel across multiple channels. This allows it to drive a variety of speaker configurations, whether you are using a simple stereo setup or a more complex surround sound system. The receiver ensures a dynamic and clear sound reproduction, enabling users to enjoy their favorite movies and music with immersive audio quality.

One of the hallmark features of the RX-6500VBK is its support for various audio formats, including Dolby Digital, DTS, and more, allowing users to experience high-definition surround sound. This makes it an ideal choice for those who want to recreate a cinema-like experience at home. The unit is also equipped with sophisticated digital signal processing that optimizes audio output based on the acoustics of your room.

In terms of connectivity, the RX-6500VBK excels with multiple HDMI inputs and outputs, making it easy to connect a range of devices, from gaming consoles to Blu-ray players and streaming devices. The HDMI ARC (Audio Return Channel) feature allows for a simplified connection to compatible TVs, ensuring that audio from the television can be channeled back to the receiver without additional cables.

In addition to HDMI, the RX-6500VBK includes analog and digital audio inputs, as well as USB ports for direct playback from flash drives. The inclusion of Bluetooth technology allows for wireless streaming from smartphones and tablets, providing added convenience for users who wish to enjoy their music collections without the hassle of wires.

Furthermore, the receiver integrates with various smart home ecosystems, facilitating voice control and automation features. The user-friendly interface, complete with an on-screen display, makes navigating through different settings and options straightforward.

For music lovers, the RX-6500VBK supports high-resolution audio formats, ensuring that every nuance of your favorite tracks is heard clearly. With its combination of power, advanced technology, and connectivity options, the JVC RX-6500VBK stands as a compelling choice for anyone looking to elevate their audio setup. Whether for movies, music, or gaming, this receiver aims to deliver an exceptional sonic experience that caters to a wide range of entertainment needs.
Top Page Image Contents