JVC RX-6500VBK manual Connecting the Speakers, AM Antenna Connections, Basic connecting procedure

Page 7

English

AM Antenna Connections

ANTENNA

Snap the tabs on the loop frame

into the slots of the base to

FM 75

assemble the AM loop.

COAXIAL

 

 

 

 

AM

LOOP AM Loop Antenna

AM

EXT

123

Outdoor single vinyl-covered wire (not supplied)

Turn the loop antenna until you have the best reception.

Notes:

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12.

For each speaker (except for a subwoofer), connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers. For connecting a subwoofer, see page 5.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Basic connecting procedure

1

2

3

 

4

 

1

1

 

1

 

 

RIGHT

RIGHT

RIGHT

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Connecting the front speakers

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

Right speaker

 

FRONT SPEAKERS 1

Left speaker

 

 

FRONT SPEAKERS

 

 

1

 

 

1

 

+

–

–

+

 

 

 

 

2

 

 

2

 

 

RIGHT

LEFT

 

Right speaker

 

FRONT SPEAKERS 2

 

Left speaker

 

 

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

 

 

CENTER

 

 

 

SPEAKER

 

Center speaker

RIGHT

LEFT

 

 

Left rear

Right rear

 

REAR

speaker

speaker

 

 

SPEAKERS

4

Page 6 Page 8
Image 7
Page 6 Page 8
Contents RX-6500VBK Errata Sheet For U.S.A Table of Contents To use the Multi Cursor buttons w on the front panel Front Panel Remote ControlParts Identification @ Û # ÜGetting Started Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersBasic connecting procedure Connecting the front speakersAudio component connections Connecting Audio/Video ComponentsConnecting the subwoofer speaker Analog connectionsIf your audio components have an AV Compu Link terminal Video component connectionsDVD player VCRBattery cover Connecting the Power CordPutting Batteries in the Remote Control On the back of the remote control, removeBasic Operations Turning the Power On and Off StandbyFrom the remote control Signal and speaker indicators on the displayMuting the Sound Selecting the Front SpeakersReinforcing the Bass Adjusting the Subwoofer Output LevelAttenuating the Input Signal Adjusting the ToneChanging the Source Name Basic SettingsAdjusting the Front Speaker Output Balance Recording a SourceFront SPK Front Speaker Setting the Speakers for the DSP ModesPress Setting repeatedly until Rear Delay appears on DisplaySelect the appropriate item about Compression level LFE ATT Low Frequency Effect Attenuator appears on DisplaySelect the low frequency effect Attenuator level Range COMP. Dynamic Range Compression appears on DisplayOn the front panel Digital Input Digital in Terminal SettingPress Multi Cursor @/ #to select an appropriate setting Selecting the Analog or Digital Input ModeStoring the Basic Settings Adjustments One Touch Operation Setting the Subwoofer InformationUsing the Sleep Timer Using Preset Tuning Tuning in Stations ManuallyReceiving Radio Broadcasts When an FM stereo broadcast is hard to receive or noisy Select a preset channel stationPress 10 keys to select a preset channel number To tune in a preset station3D-PHONIC modes Using the DSP ModesDAP modes DTS Digital Surround Headphones modeSurround modes Dolby Surround Dolby Digital and Dolby Pro LogicFront Available DSP Modes According to the Speaker ArrangementAdjusting the DAP Modes Headphones mode Adjusting the 3D-PHONIC ModesAdjusting the Surround Modes Press Test to check the speaker output balance Appropriate Surround modePress Test again to stop the test Test tone Press Surround to activete anPress Effect to select an effect Press Test again to stop the test toneSelect and play a sound source Activating the DSP ModesPress Surround so that Lamp next to the button lights upSynchronized Recording Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeCASE3 AV Compu Link Remote Control SystemCASE1 CASE2One-Touch DVD Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch Video PlayCD player Operating JVC’s Audio/Video ComponentsSound control section Amplifier TurntableREC Pause CD player-changerCassette deck MD recorderOperating Other Manufacturers’ Video Equipment Release TV PowerTry to operate your TV by pressing TV Power If there are more than one code listed for your brand of TVManufacturer Codes Release VCR PowerTry to operate your VCR by pressing VCR Power Release CATV/SAT PowerProblem Possible Cause Solution TroubleshootingHarmonic distortion SpecificationsPer channel, min. RMS, driven into 8 Ω Hz to 20 kHz with no more than 0.8% totalAM tuner FM tuner IHFGeneral Valley Road Wayne, NJ 781 954 6501099 Limited Warranty AUDIO-2 1299HIMMDWJEIN

RX-6500VBK specifications

The JVC RX-6500VBK is a versatile and powerful audio receiver designed to enhance your home theater experience. This model stands out due to its impressive combination of features, technology, and connectivity options, catering to both casual listeners and audiophiles alike.

At the core of the RX-6500VBK is its robust amplification system, which delivers an impressive power output of 100 watts per channel across multiple channels. This allows it to drive a variety of speaker configurations, whether you are using a simple stereo setup or a more complex surround sound system. The receiver ensures a dynamic and clear sound reproduction, enabling users to enjoy their favorite movies and music with immersive audio quality.

One of the hallmark features of the RX-6500VBK is its support for various audio formats, including Dolby Digital, DTS, and more, allowing users to experience high-definition surround sound. This makes it an ideal choice for those who want to recreate a cinema-like experience at home. The unit is also equipped with sophisticated digital signal processing that optimizes audio output based on the acoustics of your room.

In terms of connectivity, the RX-6500VBK excels with multiple HDMI inputs and outputs, making it easy to connect a range of devices, from gaming consoles to Blu-ray players and streaming devices. The HDMI ARC (Audio Return Channel) feature allows for a simplified connection to compatible TVs, ensuring that audio from the television can be channeled back to the receiver without additional cables.

In addition to HDMI, the RX-6500VBK includes analog and digital audio inputs, as well as USB ports for direct playback from flash drives. The inclusion of Bluetooth technology allows for wireless streaming from smartphones and tablets, providing added convenience for users who wish to enjoy their music collections without the hassle of wires.

Furthermore, the receiver integrates with various smart home ecosystems, facilitating voice control and automation features. The user-friendly interface, complete with an on-screen display, makes navigating through different settings and options straightforward.

For music lovers, the RX-6500VBK supports high-resolution audio formats, ensuring that every nuance of your favorite tracks is heard clearly. With its combination of power, advanced technology, and connectivity options, the JVC RX-6500VBK stands as a compelling choice for anyone looking to elevate their audio setup. Whether for movies, music, or gaming, this receiver aims to deliver an exceptional sonic experience that caters to a wide range of entertainment needs.
Top Page Image Contents