THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps track of the total number of hours that the treadmill has been operated and the total number of miles that the walking belt has moved. The information mode also al- lows you to select miles or kilometers as the unit of measurement and to turn on and turn off the demo mode.
To select the information mode, hold down the Stop button while inserting the key into the console. Next, release the Stop button. When the information mode is selected, the following information will be shown in the displays:
The left display will show the total number of hours that the treadmill has been used.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver in- cluded with the chest pulse sensor.
The right display will show
the total number of miles (or kilometers) that the walking belt has moved. In addition, an “E” for English miles or
an “M” for metric kilometers
will appear in the right display. Press the Speed in- crease button to change the unit of measurement if de- sired.
IMPORTANT: If a “d” appears in the right display, the console is in the “demo” mode. This mode is intended to be used only when a treadmill is displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the indicators in the displays will automati- cally appear in a preset sequence, although the but- tons on the console will not operate. If a “d” appears when the information mode is selected, press the Speed decrease button so “d” disappears.
To exit the information mode, remove the key from the console.
1.Make sure that the power cord is unplugged. Remove the 3/4” Screw (33) and the Access Door (105) from the Console Back (104).
| 104 |
Wire |
|
A |
|
Cylinder | 105 |
| 33 |
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (104). Remove the paper from the adhesive pad on the back of the receiver. Hold the receiver so the small cylinder is near the lower edge of the re- ceiver and is facing the Console Back as shown. Firmly press the receiver onto the indicated corner of the Access Door (105). Note: If there are two screws included with the chest pulse sensor and two plastic posts on the inside of the Access Door, attach the receiver to the plastic posts on the Access Door with the two screws.
3.Make sure that no wires are pinched. Reattach the Access Door (105) with the 3/4” Screw (33). The other wires included with the receiver may be dis- carded.
22