11.Slide the Left Upright Cover (80) onto the Left Upright (84) and the Right Upright Cover (86) onto the Right Upright (85).
12.With the help of a second person, hold the con- sole assembly (A) near the Right Upright (85) and the Left Upright (not shown). Insert the Upright Wire (87) into the hole in the bottom of the Right Handrail and out of the end as shown.
Connect the Upright Wire (87) to the console wire (C), See the inset drawing. The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire.
Set the console assembly (A) onto the Right Upright (85) and the Left Upright (not shown). Be careful not to pinch any wires.
Insert the wires into the Right Handrail (83). Press a Handrail Cap (63) into the end of the Right Handrail and the Left Handrail (not shown). Make sure the console wire (C) fits in the notch in the right Handrail Cap.
84
85
12
Notch A
63
87
Wire
Tie
12