13.Attach the console assembly (A) to the Left Upright (84) and the Right Upright (85) with six 5/16" x 1" Patch Bolts (4) and six 5/16" Star Washers (13), Start all six Patch Bolts before tightening any of them.
See steps 4 and 6. Tighten the 3/8" x 4 1/4" Patch Bolts (7).
14.Raise the Frame (55) to the position shown. Have a second person hold the Frame until this step is completed.
13
A
t 13
13
84 m
14
Orient the Storage Latch (51) so that the large barrel and the Latch Knob (52) are oriented as shown.
Attach the upper end of the Storage Latch (51) to the bracket on the Frame (55) with a 3/8" x 2" Bolt (8) and a 3/8" Nut (10).
Attach the lower end of the Storage Latch (51) to the bracket on the Base (95) with a 3/8" x 2" Bolt
(8)and a 3/8" Nut (10), Note: It may be neces- sary to move the Frame (55) back and forth to align the Storage Latch with the Base.
Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 21).
15.Make sure that all parts are properly tightened plastic on the treadmill decals, remove the plastic, mill. Note: Extra hardware may be included, Keep to adjust the walking belt (see pages 23 and 24).
55
before you use the treadmill. If there are sheets of clear To protect the floor or carpet, place a mat under the tread- the included hex key in a secure place; the hex key is used
13