ProForm 831.24843.0 user manual Troubleshooting, Symptom The power turns off during use

Page 20

TROUBLESHOOTING

Most treadmill prob{ems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual

SYMPTOM: The power does not turn on

Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is

plugged into a properly-grounded outlet (see page 13). Use or, ly a single-outlet surge suppressor that meets all of the specifications described on page

13. IMPORTANT: The treadmill is not compat-

ible with GFCl-equipped outlets and may not be

compatible with AFCl-equipped outlets.

b.After the power cord has been plugged in. make sure that the key is inssded into the console.

Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in,

TrippedReset

SYMPTOM: The power turns off during use

c.Remove the key from the consols, and then reinsert it.

d, If the treadmill still wilt not run, please see the front cover of this manual.

SYMPTOM: The console displays remain lit when

you remove the key from the console

a, 3he console features a display demo mode, de-

signed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the dome mode is turned on. To turn oil

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 18 to turn off the dome mode.

SYMPTOM: The displays of the console do not function properly

a.RemovethekeyfromtheconsolsandUNPLUG

THE POWER CORD. Next, remove the five indi- cated #B x 3/4" Screws (4).

a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug if, wait for five minutes, and then plug it back in.

Carefully lift the Motor Hood (48) upward_ and then slide it forward and off. Make sure that the Motor Hood does not get caught bythe tabs on Ibe sides of the Motor Hood.

2O

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model No Write 1he serial number in the space above for reterenceTable of Contents Important Precautions Page Before YOU Begin 84 emPart Identification Chart Ing is the key number Part, tram the PartExtra Hardware may Included ScrewAssembly Assembly requires two personsTo avoid damaging parts, do net use power tools To identify small paris, seeSee As described above. Note There are no wires on the left side Start all four Screws, and then tighten them Nectors Properly the Console MAY59, 64. Make sure that no wires are pinched Is on the indicated Attach Latch Housing With Spacer Left Upright Two1/2 Screws Make Sure that Large Hole Latch Operation and Adjustment NOW to Plug in the Power CordConsole Diagram Features of the Console Change the incline of the treadmill as desired HOW to Turn on the Power HOW to USE the MJ,NUAL ModeClip attached to the key see the drawing on IIm WilI dispayPlay--The CanHOW to USE a Preset Workout Information Mode HOW to USE the Crosswalk Arms CounterclockwiseHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USERemovethekeyfromtheconsolsandUNPLUG TroubleshootingSymptom The power turns off during use Symptom The incline of the treadmill does not Symptom The walking belt slows when walked onUse Exercise Guidelines Exercise IntensityPart List Exploded Drawing a Exploded Drawing B Exploded Drawing C DAY Full Warranty Sears, Roebuck and Co., Hoffman Estates, IL
Top Page Image Contents