Hold the Right Upright (76) against the Base (74). Be careful not to pinch the wires, Partially tighten three 3/8" x 3 1/4" Screws (2) with three 3t8" Star Washers (3) into the Right Upright and the Base; do not fully tighten the
Screws yet.
With the help of a second person, tip the treadmill onto its right side. Press in a Base Cap (not shown) and attach the Left Upright (not shown) as described in steps 3 and 5, Note: There are no wires on the left side.
6, Identify the Left and Right Handrails (59, 64),
which are marked "Left" and URight." Remove the four 5f16" x 3/4" Screws (5) and four 5/16" Star
Washers (6) from the bottoms and sides of each
Handrail,
Hold the Right Handrail (64) near the Right |
|
Upright (76). Insert the wire tie on the Upright |
|
Wire {63) through the hole in the bottom and |
|
out of the hole in the side of the Left Handrail as |
|
shown. Then, pull the Upright Wire through the |
|
Right Handrail. | 59 |
Attach the Right Handrail (64) to the Right
Upright (76) with fwo of the 5/16" x 3f4" Screws
(5)and two of the 3/8" Star Washers (6) that you just removed. Make sure not to pinch the Upright Wire (63), Start both Screws, and then tighten them.
Attach the Left Handrail (59) to the Left Upright