Problem The incline will not work | ProForm 831.2916 specs

PROBLEM: The incline will not work

SOLUTION: a. Make sure that the two wires under the console are fully plugged in. (Refer to assembly step 4 on page 6. WARNING: Do not disconnect or connect the wires while the treadmill power cord is

plugged in.)

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 7.

	If the walking belt is overtightened, treadmill perfor-
	mance may decrease and the walking belt may be-
	come damaged. Remove the key and UNPLUG THE
	POWER CORD. Using the allen wrench, turn both
	rear roller adjustment bolts counterclockwise, 1/4 of a
	turn. When the walking belt is properly tightened, you
	should be able to lift each side of the walking belt 2 to
	3 inches off the walking platform. Be careful to keep
	the walking belt centered. Plug in the power cord, in-
	sert the key and run the treadmill for a few minutes.	Rear Roller Adjustment Bolts
	Repeat until the walking belt is properly tightened.	Rear Roller Adjustment Bolts
	Repeat until the walking belt is properly tightened.

c. If the walking belt still slows when walked on, please call our toll-free HELPLINE

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt has shifted to the left, first re- move the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller bolt clockwise 1/2 of a turn. Be careful not to overtighten the walking belt. If the walking belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tight- ened, you should be able to lift each side of the walk- ing belt 2 to 3 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.