ProForm 985 user manual

Page 4



20.	Never leave the treadmill unattended while it		24.	Inspect and properly tighten all parts of the
	is running. Always remove the key, unplug			treadmill regularly.
	cuit breaker to the off position when the		25. DANGER: Always unplug the power
	the power cord, and switch the reset/off cir-			cord immediately after use, before cleaning the
	treadmill is not in use. (See the drawing on
	page 5 for the location of the circuit breaker.)			treadmill, and before performing the mainte-
21.	Do not attempt to raise, lower, or move the			nance and adjustment procedures described in
				this manual. Never remove the motor hood un-
	treadmill until it is properly assembled. (See			less instructed to do so by an authorized ser-
	ASSEMBLY on page 6, and HOW TO FOLD			vice representative. Servicing other than the
	AND MOVE THE TREADMILL on page 21.)			procedures in this manual should be performed
	You must be able to safely lift 45 lbs. (20 kg)			by an authorized service representative only.
22.	to raise, lower, or move the treadmill.		26. This treadmill is intended for in-home use
	When folding or moving the treadmill, make			only. Do not use this treadmill in a commer-
	sure that the storage latch is holding the			cial, rental, or institutional setting.
23.	frame securely in the storage position.
	Never insert any object into any opening on
	the treadmill.	SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. PFTL16008.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Pulse sensors are not medical devicesPage Before YOU Begin Assembly Page Pinch the Wire Harness 84. Partially tighten Bolts touch the Base do not fully tighten Patch Bolts yetNot fully fold the Frame yet Overtighten the Nut the Wheels must turn FreelyTouch the Base do not fully tighten the Patch Bolts yet Tighten the Bolts yetFul not to pinch the wires Inset drawing. The connectors should slideTogether easily and snap into place. If they do Be careful not to pinch the wires in the Right Handrail Raise the Frame 51 to the position shown HOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorChest Pulse Sensor Care and Maintenance HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleMeasure your heart rate if desired HOW to USE a Preset Workout Select one of the preset workouts. To select oneHOW to USE AN Ifit Workout Insert an iFit card and select a workoutHOW to USE the Stereo Sound System Information ModeHOW to Adjust the Cushioning System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on TopProblem The chest pulse sensor does not function properly Turn if the walking belt has shifted to the rightExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL16008.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PFTL16008.0 R0109A Exploded Drawing B-Model No. PFTL16008.0 R0109A Exploded Drawing C-Model No. PFTL16008.0 R0109A Exploded Drawing D-Model No. PFTL16008.0 R0109A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT