ProForm PFTL06009.0 user manual

Page 4

20. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)

21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 21.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22. When folding or moving the treadmill, make sure that the frame is held securely in the storage position.

23. Never insert any object into any opening on the treadmill.

24. Inspect and properly tighten all parts of the treadmillDANGER:regularly.

25.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the mainte- nance and adjustment procedures described in this manual. Never remove the motor hood un- less instructed to do so by an authorized ser- vice representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

26. This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. PFTL06009.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Pulse sensor is not a medical device Important PrecautionsVarious factors, including the users move Page Before YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedOvertighten the Nut the Wheel must turn Freely With a second Bolt Spacer 82, 3/8 x 4 Bolt 3/8 Star WasherRight Upright do not fully tighten the Bolts Yet Not fully fold the Frame yetBolts yet See assembly steps 4 and 6. Firmly tighten the 3/8 x 4 Bolts Raise the Frame 52 to the position shown Be careful not to pinch the wires. ReattachThis step is completed HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeMonitor your progress with the displays. The matrix-When you Measure your heart rate if desiredHOW to USE a Preset Workout Start the walking beltHOW to USE the Custom Workout Center Select the Custom Workout CenterHOW to USE the Weight Loss Workout Center Select a weight loss workoutHOW to USE the Sound System Monitor your progress with the displays. See onHOW to USE AN Ifit Card Insert an iFit card and select a workoutInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Knob is locked in the storage positionProblem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Problem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL06009.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PFTL06009.0 R0709A Exploded Drawing B-Model No. PFTL06009.0 R0709A Exploded Drawing C-Model No. PFTL06009.0 R0709A Exploded Drawing D-Model No. PFTL06009.0 R0709A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT