11. Raise the Frame (52) to the position shown. |
Have a second person hold the Frame until |
this step is completed. |
11
52
Orient the Storage Latch (49) so that the large |
barrel and the Latch Knob (50) are in the posi- |
tions shown. |
Attach the upper end of the Storage Latch (49) |
to the bracket on the Frame (52) with a 3/8" x 2" |
Bolt (6) and a 3/8" Nut (7). |
Attach the lower end of the Storage Latch (49) to |
7
6
49 
50 
the Base (84) with a 3/8" x 1 3/4" Patch Bolt (2). |
Note: It may be necessary to move the Frame |
(52) back and forth to align the Storage Latch |
with the Base. |
Lower the Frame (52) (see HOW TO LOWER THE TREADMILL FOR USE on page 21).
Large
Barrel84
2
12.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 23 and 24).
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. | 95 |
|
|
Remove the indicated #8 x 1/2" Screw (12) and | Small |
| |
the Access Door (92) from the Console Back |
|
| |
(95). |
| Screws | Antenna |
2. Connect the wire on the receiver to the indicated |
| Receiver | |
wire extending from the Console Back (95). |
|
|
|
Hold the receiver so the antenna is oriented |
|
| 92 |
as shown and is facing the Console Back. |
|
| |
Attach the receiver to the plastic posts on the |
|
|
|
Access Door (92) with the two included small |
| Wire | 12 |
screws. |
| ||
3. Be careful not to pinch the wires. Reattach |
|
|
|
the Access Door (92) with the #8 x 1/2" Screw |
|
|
|
Screw (12). Discard the other wires included |
|
|
|
with the receiver. |
|
|
|
11