Remove the four #8 x 3/4" Screws (14) and carefully |
|
|
|
|
remove the Motor Hood (61). |
| 61 | 14 |
|
|
| 14 | ||
|
|
| ||
|
|
|
| |
Locate the Reed Switch (44) and the Magnet (43) |
|
|
|
|
on the left side of the Pulley (42). Turn the Pulley |
|
|
|
|
until the Magnet is aligned with the Reed Switch. |
|
|
|
|
Make sure that the gap between the Magnet |
| 1/8 in. |
|
|
and the Reed Switch is about 1/8 in. (3 mm). If |
|
|
| |
necessary, move the Reed Switch slightly using a |
| 44 |
| 43 |
slotted screwdriver. Reattach the Motor Hood (not |
|
| ||
shown) with the four #8 x 3/4" Screws (not shown) |
| Top |
| 42 |
and the two #8 x 1 1/2" Screws (not shown). Run |
|
| ||
the treadmill for a few minutes to check for a cor- |
| View |
|
|
rect speed reading. |
|
|
|
|
PROBLEM: The incline of the treadmill does not change correctly |
|
|
|
|
SOLUTION: a. Hold down the Stop button and the Speed increase button, insert the key into the console, and | ||||
then release the Stop button and the Speed increase button. Press the Stop button and then | ||||
press the Incline increase or decrease button. The treadmill will automatically rise to the maxi- | ||||
mum incline level and then return to the minimum level. This will recalibrate the incline system. If the | ||||
incline does not calibrate, press the Stop button, and then press the Incline increase or decrease | ||||
button again. When the incline is calibrated, remove the key from the console. |
|
| ||
PROBLEM: The walking belt slows when walked on |
|
|
|
|
SOLUTION: a. Use only a | ||||
b. If the walking belt is overtightened, treadmill perfor- | b |
|
|
|
mance may decrease and the walking belt may be- |
|
| ||
come damaged. Remove the key and UNPLUG |
|
|
| |
THE POWER CORD. Using the hex key, turn both |
|
|
|
|
idler roller bolts counterclockwise, 1/4 of a turn. |
|
|
|
|
When the walking belt is properly tightened, you |
|
|
|
|
should be able to lift each edge of the walking belt |
|
|
|
|
2 to 3 in. (5 to 7 cm) off the walking platform. Be |
|
|
|
|
careful to keep the walking belt centered. Then, |
|
|
|
|
plug in the power cord, insert the key, and run the | Idler Roller Bolts |
|
| |
treadmill for a few minutes. Repeat until the walking |
|
| ||
belt is properly tightened. |
|
|
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual. |
| |||
26