ProForm PFTL10909.0 R1009A warranty

Page 4
20. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)
21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 23.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
22. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.
23. Never insert any object into any opening on the treadmill.

24. Inspect and properly tighten all parts of the treadmillDANGER:regularly.

25.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the mainte- nance and adjustment procedures described in this manual. Never remove the motor hood un- less instructed to do so by an authorized ser- vice representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

26. This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

27. Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents QUESTIONS? Model No. PFTL10909.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Attach the other Wheel 95 in the same way Page Do not fully fold the Frame yet Not fully tighten the Patch Bolts yetTouch the Upright do not fully tighten Patch Bolts yet 2 Patch Bolt 4. Do not tighten the Patch Bolts yet To overtighten the ScrewsPatch Bolts used in this step. Slide Patch Bolts yet. Be careful not to pinch Upright Wire Again. if the Connectors are not CONStart all six Patch Bolts before tightening any of them On page 17 and lower the incline to the low HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired. Before using Select a preset workout HOW to USE a Preset WorkoutStart the workout See on HOW to USE a Competition Workout Select a competition workoutSee on HOW to USE the Ifit Live Mode Information Mode HOW to USE the Stereo Sound SystemHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part LIST-Model No. PFTL10909.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PFTL10909.0 R1009A Exploded Drawing B-Model No. PFTL10909.0 R1009A 107 Exploded Drawing D-Model No. PFTL10909.0 R1009A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT