ProForm PCTL55810 Important Precautions, Use the treadmill only as described, Sion cord

Page 3

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill.

1.It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.

2.Use the treadmill only as described.

3.Place the treadmill on a level surface, with at least eight feet of clearance behind it and two feet on each side. Do not place the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.

4.Keep the treadmill indoors, away from mois- ture and dust. Do not put the treadmill in a garage or covered patio, or near water.

5.Do not operate the treadmill where aerosol products are used or where oxygen is being administered.

6.Keep children under the age of 12 and pets away from the treadmill at all times.

7.The treadmill should not be used by persons weighing more than 115 kg (250 lbs.).

8.Never allow more than one person on the treadmill at a time.

9.Wear appropriate exercise clothing when

using the treadmill. Do not wear loose cloth- ing that could become caught in the treadmill. Athletic support clothes are recommended for

both men and women.

Always wear athletic

shoes. Never

use the treadmill with bare feet,

wearing only

stockings, or in sandals.

 

10.When connecting the power cord (see page 9), plug the power cord into a surge suppressor (not included) and plug the surge suppressor into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Do not use an extension cord.

11.Use only a CUL-listed surge suppressor of 450 joules minimum surge dissipation with voltage rating of 400 volts or less, rated at 15

amps, with a 1 mm 2 (14-gauge) cord of 1.5 m (5 ft.) or less in length. Do not use an exten-

sion cord.

12.Failure to use a properly functioning surge suppressor could result in damage to the con-

trol system of the treadmill. If the control sys- tem is damaged, the walking belt may change

speed or stop unexpectedly, which may result in a fall and serious injury.

13.Keep the power cord and the surge suppres-

sor away from heated surfaces.

14. Never move the walking belt while the power is turned off. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See BEFORE YOU BEGIN on page 5 if the tread- mill is not working properly.)

15.Never start the treadmill while you are stand- ing on the walking belt. Always hold the handrails while using the treadmill.

16.The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.

17.The pulse sensor is not a medical device. Various factors, including the user's move- ment, may affect the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in general.

18.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord and move the on/off switch to the off position when the treadmill is not in use. (See the drawing on page 5 for the loca- tion of the on/off switch.)

19.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 15.) You must be able to safely lift 20 kg (45 lbs.) in order to raise, lower, or move the treadmill.

20.Do not change the incline of the treadmill by placing objects under the treadmill.

21.When folding or moving the treadmill, make

sure that the storage latch is fully closed.

Image 3
Contents QUESTIONS? Model No. PCTL55810 Serial NoSerial Number Decal Table of Contents Sion cord Important PrecautionsUse the treadmill only as described Wear appropriate exercise clothing whenPage Right Side Using the treadmillBefore YOU Begin Left SideCord until the treadmill is completely assembled AssemblyAssembly requires your own Phillips screw Driver Rubber mallet101 Post ThreeInto the indicated holes LargeFloor or carpet from damage, place a mat under the treadmill HOW to Plug in the Power Cord Performant LubeThis product must be grounded.If it should malfunc Features of the Console Console DiagramHOW to USE the Manual Mode TIME/INCLINE/SEGCALS./FAT Cals 7Whenkey. you are finished exercising, remove Pulse sensorsTo start the program HOW to USE Personal Trainer ProgramsTomatically adjust to Settings for the programIf a d appears Information MODE/DEMO ModeInformation mode is selected, press the Speed Optional Hand WeightsUneven surface HOW to Fold the Treadmill for StorageHOW to Move the Treadmill Carefully move the treadmill to the desired locationHOW to Lower the Treadmill for USE Hold the upper end of the treadmill with your right handHold the treadmill firmly with both hands, and lower Solution TROUBLE-SHOOTINGProblem The walking belt slows when walked on Shifted to the leftChanging, remove the key Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description 107 Pulse Bar Bolt 108 Pulse Bar Washer112 Shield Ordering Replacement Parts Part No R0802A Limited WarrantyR0802A Exploded DRAWING-Model No. PCTL55810