3.With the help of a second person, carefully tip the Uprights
(82)back to the vertical position.
Attach the Latch Assembly (9) and the Latch Spacer (56)
to the left Upright (82) with two Screws (101) as shown.
4.Insert a Handrail Extension (85) into the post on the left Upright (82). Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach
the Handrail Extension by tightening | three | Small Screws |
(76) into the indicated holes. | Note: If there is only one | |
hole in the top of the post, tighten the third Small |
| |
Screw into the hole in the left side of the post. |
| |
Identify the Left Foam Grip (110), which has a | large | |
cutout in the right side. Slide the Left Foam Grip as far as |
| |
possible onto the post on the left Upright (82). | It may be | |
helpful to apply soapy water to the Handrail Extension (85). |
| |
5.Make sure that the front edge of the Left Foam Grip (110) is under the Console Base (87) as shown. Tighten a Small Screw (76) into the side of the Left Foam Grip as shown. Note: You may need to pull on the side of the Left Foam Grip to align the Small Screw with the hole in the Upright (82).
Attach the Right Foam Grip (not shown) and the other Handrail Extension (not shown) as described in step 4 and this step.
Note: Extra screws may be included.
3 |
| |
| 56 | |
| 9 | |
| 82 | |
101 | 101 | |
| ||
4 |
| |
| Post | |
| 76 | |
| 85 | |
Cutout |
| |
110 | 76 | |
82 | ||
| ||
| 76 | |
5 | 87 | |
| ||
| 76 | |
| 110 | |
| 76 | |
| 82 |