14.Have a second person lift and hold the Frame
(51)until step 15 is completed.
Place the cylinder end of the Gas Spring (129) near the bracket on the Base (52).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Gas Spring Clip (128) to loosen it from the Gas Spring (129). Next, rotate the Gas Spring Clip and pull it out of the Gas Spring. Be careful to avoid losing the Gas Spring Clip. See the lower drawing. Press the cylinder end of the Gas Spring (129) onto the ball on the bracket. Next, insert the end of the Gas Spring Clip (128) through two of the small holes in the end of the Gas Spring. Then, rotate the Gas Spring Clip until it clips onto the Gas Spring.
15.Raise the Gas Spring (129) to a vertical posi- tion. Remove the Gas Spring Clip (128) from the raised end of the Gas Spring as described in step 14. If necessary, rotate the Gas Spring to align the end of the Gas Spring with the ball on the bracket on the Frame (51).
Then, press the end of the Gas Spring (129) onto the ball. Note: It may be necessary to move the Frame (51) forward or backward as you press the Gas Spring onto the ball.
See the lower drawing. Insert the Gas Spring Clip (128) into the two indicated small holes in the end of the Gas Spring (129). Then, rotate the Gas Spring Clip until it clips onto the Gas Spring. Note: Extra Gas Spring Clips are in- cluded.
Lower the Frame (51) to the floor.
14 |
|
|
|
|
| 51 |
|
|
|
| 128 |
52 | 128 | Bracket | 128 |
129 |
| ||
| Cylinder |
| |
| 129128 |
| Bracket |
| Holes |
| |
15 | 51 | Bracket |
|
|
| ||
| 128 | 129 |
|
|
|
| |
Holes 
128 
129
16.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. One hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor or carpet, place a mat under the treadmill.
13