4. Position the Base (52) as close to the front of the | 4 |
|
|
|
|
|
treadmill as possible, as shown. | 39 |
| 39 |
| 54 | |
See the upper inset drawing. Locate the wire |
|
|
| |||
tie in the lower end of the Right Upright (54). Tie |
|
|
|
| Wire Tie | |
the wire tie securely around the end of the Wire |
| 54 |
|
| ||
Harness (39). Then, locate the other end of the |
|
|
|
|
| |
wire tie in the upper end of the Right Upright. |
|
|
|
|
|
|
Pull the upper end of the wire tie until the Wire |
| 52 |
|
|
|
|
Harness is extending from the upper end of the |
|
|
|
|
| |
Right Upright. Secure the Wire Harness to the |
|
|
| 52 |
|
|
Right Upright so that it will not fall inside. |
|
|
|
| 54 | |
See the lower inset drawing. Press the indi- |
|
|
|
|
| |
cated Grommet (49) into the Right Upright (54). |
|
|
|
|
|
|
|
|
|
| 39 | 49 |
|
|
|
|
|
|
| |
5. See the left inset drawing. Identify the two | 5 |
|
|
|
|
|
Frame Spacers (11). Open the included packet |
|
|
|
|
| |
of grease, and apply grease to both sides of both |
|
|
|
|
|
|
Frame Spacers. Then, identify the outer side of |
|
|
|
|
|
|
each Frame Spacer. |
|
|
|
| 54 |
|
Hold a Frame Spacer (11) between the Right |
|
|
|
|
| |
Upright (54) and the Lift Frame (23), with the |
|
|
|
|
|
|
outer side of the Frame Spacer facing the |
|
|
|
|
|
|
Right Upright. |
|
|
|
| 9 |
|
With the help of a second person, lift the front of |
|
|
|
|
| |
the treadmill. Attach the Lift Frame (23) to the |
|
|
| 11 | 14 | 1 |
Right Upright (54) with an M10 x 60mm Patch |
|
|
|
| ||
Bolt (1), an M10 Flat Washer (14), and an M10 |
|
| 23 |
|
|
|
Star Washer (9); do not fully tighten the Patch |
|
|
|
|
| |
Bolt yet. |
| Grease |
| Top View |
| |
|
|
|
| |||
|
| 11 |
| 11 | 14 | 1 |
|
|
|
| 9 |
| |
|
| Outer Side |
| 23 |
| |
|
|
|
| 54 |
| |
| 8 |
|
|
|
|
|