ProForm PATL49708.0 user manual Make sure that the power cord is unplugged

1.	Make sure that the power cord is unplugged.	1	26	52		26
	Position the Base (52) and the Base Extensions					63		26
	(45, 120) upside-down as shown.		63				63
	Attach six Base Feet (63) to the Base (52) and
	the Base Extensions (45, 120) with six #8 x 1"		26 63			26
	Tek Screws (26).
			45	63	120	63
			26
2. Have a second person hold the Base (52) in the		2
	position shown.
	Identify the Right Upright (54) which has a				Round Holes
	square hole near the lower end.
	Hold the Right Upright (54) so the two round					Square
	holes are on top as shown. Attach the Right
	Upright to the Base (52) with two M10 x 75mm		Round Holes	54		Hole
	Bolts (2) and two M10 Star Washers (9). Do not							2
	fully tighten the Bolts yet.
	Attach the Left Upright (53) to the Base (52) in					52	9
	the same way.		53		9
						2
3. Attach the Right Base Extension (45) and the		3
	Left Base Extension (120) to the Base (52) with
	four M8 x 58mm Bolts (13), four M8 Flat
	Washers (32), and four Base Extension Nuts
	(43).
	Lower the Base (52) so that it is flat on the floor.			13		32	45
			120				43
			13		43	52
			32
		7