ProForm PATL49708.0 user manual Problem Solution

Page 24

PROBLEM:

SOLUTION:

The walking belt is off-center or slips when walked on a. If the walking belt has shifted to the left, first re-

move the key and UNPLUG THE POWER CORD. Using the hex key, turn the left idler roller bolt clock- wise 1/2 of a turn. Be careful not to overtighten the walking belt. If the walking belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 of a turn. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts clock- wise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking plat- form. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and care- fully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

24

Image 24

Contents QUESTIONS? Model No. PATL49708.0 Serial NoTable of Contents Important Precautions Tenance and adjustment procedures de Before YOU Begin Assembly Make sure that the power cord is unplugged Hold the Right Upright 54 so the two roundHoles are on top as shown. Attach the Right See the upper inset drawing. Locate the wire See the lower inset drawing. Press the indiSee the left inset drawing. Identify the two Outer side of the Frame Spacer facing Right UprightTop View Console Tie Wire Bracket Large Hole Again. if the Connectors are not CON Be Damaged When the Power is Turned onNected PROPERLY, the Console MAY Then, firmly tighten all six BoltsPage Top View Page Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltMeasure your heart rate if desired Turn on the fan if desiredHOW to USE a Preset Workout Information Mode HOW to USE the Crosswalk ArmsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The crosswalk arms squeak during use Problem The walking belt slows when walked onProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PATL49708.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PATL49708.0 R0809A R0809A Exploded Drawing C-Model No. PATL49708.0 Exploded Drawing D-Model No. PATL49708.0 Ordering Replacement Parts Limited WarrantyIcon Authorized Dealer