PART | R1104A |
To locate the parts listed below, see the EXPLODED DRAWING attached in the center of this manual.
Key No. | Qty. | Description | Key No. | Qty. | Description |
1 | 1 | Left Foot Rail | 51 | 2 | Static Decal |
2 | 12 | Foot Rail Screw | 52 | 10 | 3/4” Tek Screw |
3 | 2 | Isolator Bolt (Top) | 53 | 3 | Belly Pan Clip |
4 | 2 | Isolator Decal | 54 | 1 | Belly Pan |
5 | 2 | Isolator Top Cap | 55 | 1 | Releasable Tie |
6 | 2 | Front Isolator | 56 | 1 | Photo Switch Wire |
7 | 2 | Isolator | 57 | 1 | Tie Holder Clamp |
8 | 2 | Isolator Bottom Cap | 58 | 1 | Cable Tie |
9 | 2 | Isolator Bracket Cover | 59 | 1 | Frame |
10 | 2 | Isolator Bracket | 60 | 1 | Right Rear Foot |
11 | 4 | Isolator Bracket Bolt | 61 | 1 | Motor Bracket |
12 | 2 | Isolator Bolt | 62 | 2 | Rear Roller Adj, Bolt |
13 | 1 | Walking Platform | 63 | 1 | Rear Roller |
14 | 2 | Belt Guide | 64 | 1 | Allen Wrench |
15 | 4 | Belt Guide Screw | 65 | 1 | 5/32” Allen Wrench |
16 | 2 | Walking Platform Screw (Rear) | 66 | 1 | Left Rear Foot |
17 | 2 | Frame Pivot Bolt | 67 | 1 | Right Foot Rail |
18 | 1 | Front Roller/Pulley | 68 | 1 | Walking Belt |
19 | 1 | Magnet | 69 | 1 | Warning Decal |
20 | 8 | Pivot Nut | 70 | 1 | Filter Wire |
21 | 2 | Pivot Bushing | 71 | 1 | Pulse Bar |
22 | 1 | Reed Switch | 72 | 1 | Cotter Pin |
23 | 1 | Reed Switch Screw | 73 | 1 | Photo Switch Star Washer |
24 | 1 | Reed Switch Clip | 74 | 1 | Wire Harness |
25 | 1 | Motor Tension Bolt | 75 | 1 | Right Top Endcap |
26 | 1 | Motor Tension Washer | 76 | 4 | Upright Bolt |
27 | 1 | Ground Wire | 77 | 4 | Internal Star Washer |
28 | 1 | Motor Pulley | 78 | 2 | Front Isolator Screw |
29 | 1 | Motor Star Washer | 79 | 2 | Small Upright Endcap |
30 | 1 | Motor Tension Nut | 80 | 4 | Extension Leg Bolt |
31 | 1 | Drive Motor | 81 | 1 | Left Top Endcap |
32 | 1 | Right Bottom Handgrip | 82 | 1 | Latch Assembly |
33 | 1 | Lift Frame | 83 | 1 | Controller Wire |
34 | 1 | Right Handrail | 84 | 1 | Leveling Foot |
35 | 2 | Walking Platform Nut | 85 | 1 | Shock |
36 | 1 | Motor Pivot Pin | 86 | 1 | Hood Cover |
37 | 1 | Incline Motor | 87 | 1 | Hood Decal |
38 | 2 | Incline Motor Bolt | 88 | 5 | Hood Cover Screw |
39 | 6 | 1/4” Washer | 89* | 2 | Extension Leg Assembly |
40 | 4 | 1” Tek Screw | 90 | 2 | Wheel Bolt |
41 | 1 | Front Roller Adj. Bolt | 91 | 2 | Warning Decal |
42 | 2 | Walking Platform Screw (Front) | 92 | 2 | Extension Leg |
43 | 1 | Left Bottom Handgrip | 93 | 1 | Console Back |
44 | 5 | Hood Screw | 94 | 2 | Wheel |
45 | 2 | Star Washer | 95 | 2 | Controller Screw |
46 | 2 | Latch Screw | 96 | 1 | Access Door |
47 | 1 | Reset/Off Circuit Breaker | 97 | 1 | Upright Base |
48 | 1 | Controller | 98 | 1 | Photo Switch |
49 | 1 | Power Cord | 99 | 4 | Base Pad |
50 | 1 | Power Cord Grommet | 100 | 2 | Upright Base Endcap |
26