ProForm DTL62950 user manual Upright Base

Page 6

2.With the help of a second person, carefully tip the Uprights (97) down as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [92] as you tip the Uprights.) Make sure that the Extension Legs remain in the Uprights.

Attach each Extension Leg (92) with two Extension Leg Bolts (96) and two 1/4” Washers (39) as shown. Thread a Leveling Foot (95) into each side of the Upright Base (97); do not thread the Leveling Feet fully into the

Upright Base.

Attach the two Base Pads (99) to the Upright Base (97) in the locations shown with two 1” Tek Screws (80).

With the help of a second person, raise the Upright Base (97) to the vertical position.

3.Attach the Latch Assembly (82) to the left Upright (97) with the two Latch Screws (79); start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the left Upright.

4.See drawing 4c. With the help of a second person, hold the Console Base (101) near the Uprights (80, 84). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (109,

111). Drawing 4a shows the correct route for the wires. Drawing 4b shows an incorrect route.

See drawing 4c. Cut the plastic ties holding the Wire Harness (74) and the pulse wire in the Uprights (97).

Locate the Wire Harness (74) and the pulse wire in the Uprights (97). Connect the Wire Harness and the pulse wire to the connectors on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). The connectors should slide together easily and snap into place. If the con- nectors do not slide together easily and snap into place, turn one connector and try again to insert it. IF THE

CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the excess Wire Harness and pulse wire up into the Console Base.

2

 

 

 

 

99

 

 

 

 

 

 

 

 

 

 

80

 

99

 

 

 

 

 

 

 

 

 

96

 

 

80

 

 

95

 

 

 

 

39

 

 

 

 

97

92

96

 

 

 

 

 

 

 

 

 

 

39

96

 

 

 

97

 

 

 

 

 

95

 

 

 

 

 

 

 

 

92

39

96

 

 

 

3

 

 

 

 

 

 

79

82

 

 

 

 

 

 

 

 

 

 

 

 

97

 

4a

 

 

4b

 

 

 

Correct

 

 

Incorrect

 

4c

 

 

 

 

 

 

111

109

 

 

74

101

 

 

 

 

 

 

 

 

 

97

 

 

97

 

 

Pulse

74

Wire

 

6

Image 6
Contents QUESTIONS? Model No. DTL62950 Serial NoCustomer HOT Line Table of Contents Important PrecautionsPage Before YOU Begin Right SideBack Assembly Make sure that the power cord is unpluggedUpright Base 107 Wire 116 Cylinder 108 Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeAvoid mov Measure your heart rate if desiredOn the foot Rails Turn on the fan if desiredHOW to USE a Preset Program Select one of the preset programsHOW to USE a Heart Rate Program Select a heart rate programEnter a maximum speed setting Enter your ageHOW to Connect Your MP3 Player or CD Player HOW to Connect Your Portable StereoAudio Cable HOW to Connect Your Home Stereo HOW to Connect Your ComputerHOW to Connect Your VCR Press the Play button on your MP3 player, CD Player, or VCRMeasure your heart rate if desired Directly from OUR WEB Site Follow the on-line instructions to start ProgramReturn to the treadmill and stand on the foot Information MODE/DEMO Mode HOW to Level the TreadmillOptional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem The walking belt slows when walked on TopWorkout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R1104A Qty DescriptionQty Exploded DRAWING-Model No. DTL62950 108 109 111 101 103 100 112 107 104 HOW to Order Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT