ProForm Not AvailablePFTL13810.0 HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 20

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight.

1

Frame

2.Raise the frame until the latch knob locks in the storage position. CAUTION: Make sure that the latch knob locks.

2 Frame

Latch Knob

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch knob is locked in the storage position. Moving the tread- mill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame Handrail

Wheel

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the treadmill frame with your right hand. Pull the latch knob to the left; if necessary, push the frame forward slightly. Pivot the frame downward a few inches, and release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

20

Image 20
Contents QUESTIONS? Model No. PFTL13810.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Tipping, or falling Make sure that the power cord is unpluggedTo pinch the Upright Wire Nectors should slide together easily Wire 114. See the inset drawing. The conYOU Turn on the POWER. Next, remove Wires are pinched Raise the Frame 67 to the position shown PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired. Before using Start the workout HOW to USE a Performance WorkoutSelect a performance workout HOW to Create a MY Memory Workout Select a my memory workoutHOW to USE a MY Memory Workout Start the walking beltHOW to USE the Ifit Training Mode Information ModeHOW to USE the Stereo Sound System HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USECompatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on TopUnplug the Power CORD. If the walking belt Key and Unplug the Power CORD. UsingProblem The console display has lines running through it Walking belt has shifted to the right, turn the leftExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL13810.0 Qty DescriptionDescription Key No. Qty Exploded Drawing A-Model No. PFTL13810.0 R1010A Exploded Drawing B-Model No. PFTL13810.0 R1010A Exploded Drawing C-Model No. PFTL13810.0 R1010A Exploded Drawing D-Model No. PFTL13810.0 R1010A Exploded Drawing E-Model No. PFTL13810.0 R1010A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty