Lower the treadmill (see HOW TO LOWER THE |
| 1 | 1 |
TREADMILL FOR USE on page 20). Remove the four | 75 | ||
indicated #8 x 3/4" Screws (1), and remove the Motor |
|
| |
Hood (75). |
|
|
|
Next, locate the Reed Switch (53) and the Magnet | Top |
|
(58) on the left side of the Pulley (59). Turn the Pulley |
| |
until the Magnet is aligned with the Reed Switch. | View |
|
Make sure that the gap between the Magnet and | 24 | 1/8 in. |
the Reed Switch is about 1/8 in. (3 mm). If neces- | ||
sary, loosen the indicated #8 x 3/4" Tek Screw (24), |
| 59 |
move the Reed Switch slightly, and then retighten the | 53 | |
Screw. Then, reattach the Motor Hood (not shown) | 58 | |
with the six #8 x 3/4" Screws (not shown), and run the |
|
|
treadmill for a few minutes to check for a correct |
|
|
speed reading. |
|
|
PROBLEM: The walking belt slows when walked on |
|
|
SOLUTION: a. Use only a
mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few min- utes. Repeat until the walking belt is properly tight- ened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
22