1. Make sure that the power cord is unplugged. | 1 |
|
|
|
With the help of a second person, raise the front |
|
|
|
|
of the treadmill and insert the crossbar on the |
|
|
|
|
Base (103) into the cutout in the cardboard |
|
|
|
|
stand as shown. Have the second person hold |
|
|
|
|
the treadmill until assembly step 3 to prevent |
|
|
|
|
it from moving forward or backward. |
|
|
|
|
WARNING: Serious injury |
|
|
|
|
may occur if the treadmill moves for- |
|
|
|
|
ward or backward and falls off the card- |
|
|
|
|
board stand. A second person must |
|
|
|
|
hold the treadmill until assembly step 3 |
|
|
|
|
to prevent the treadmill from moving, |
|
| 103 |
|
tipping, or falling. |
|
| Cardboard | |
|
|
|
| |
|
|
|
| Stand |
2. Identify the Right Upright (92), which is marked | 2 |
| Wire |
|
with a “Right” sticker. |
|
| ||
Have a second person hold the Right Upright |
|
| Tie | 93 |
(92) near the Right Base Cover (102). See the |
|
|
| |
inset drawing. Tie the wire tie in the lower end |
| 91 |
|
|
of the Right Upright securely around the end of |
|
|
| |
the Upright Wire (93). Then, pull the other end |
|
|
|
|
of the wire tie in the top of the Right Upright until |
|
|
| 92 |
the Upright Wire is routed completely through |
|
|
| |
the Right Upright. |
|
|
|
|
Gently pull up on the Upright Wire (93) as you |
|
|
| 102 |
set the Right Upright (92) on the Base (103) in- |
|
|
| |
side the Right Base Cover (102). Be careful not |
|
|
| 103 |
to pinch the Upright Wire. |
|
|
| |
Attach the Right Upright (92) to the Base (103) |
|
|
|
|
with two 3/8" x 3 3/4" Patch Bolts (5) and two |
|
|
| 6 |
3/8" Star Washers (6). Note: It may be neces- |
|
|
| |
sary to tip the top of the Right Upright forward |
|
|
|
|
slightly as you thread the Patch Bolts into it. Do | 92 | 93 |
| 5 |
not tighten the Patch Bolts yet. |
| |||
Attach the Left Upright (91) in the same way. |
| Wire |
|
|
Note: There are no wires on the left side. |
| Tie |
|
|
| 7 |
|
|
|