ProForm 595 lt warranty Again. if the Connectors are not CON, That no wires are pinched

10. Remove the plastic ties from the Right Handrail	10
(90) and the Left Handrail (not shown). If neces-				Console Assembly
sary, press the Cage Nuts (38) into place.
Have a second person hold the console assem-
bly near the Right Upright (78).
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY		38
BE DAMAGED WHEN THE POWER IS				90
TURNED ON. Remove the wire tie from the	Plastic				Console
Upright Wire and the tie from the console wire.		Ties		Console
Then, insert the connectors into the Right Upright		77		Wire	Wire
(78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure			Wire		77
that no wires are pinched.		78
				Tie
11. Partially tighten two M8 x 25mm Bolts (6) with	11
two M8 Star Washers (10) into the Left Upright
(73) and the Left Handrail (89).					110
Next, partially tighten two M8 x 25mm Bolts (6)						111
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,
tighten all four Bolts.			88
See steps 4 and 6. Tighten the M10 x 96mm
Bolts (5).	89
Press the Left Accessory Tray (110) and the
Right Accessory Tray (111) into the Console			10	6
Base (88).	6	10
				73	90
							10	6
					6	10	78
	11