5.Move your dght hand to the position shown at the right, and hold the treadmiti firmly. Using your left hand, rift the storage latch. Raise the treadmill until the lockingpin
•snaps into the storage latch. Make sure that the locking pln Is Inslde the storage latch, and that the storage latch Is fully closed.
. See the upper Inset drawing. Attach a Base Pad (95) to the bottomof the Stabilizer Plate (81) in the indicated lo- cation.
Stand behind the lreadmilL Hold the Right Crossbar
Bracket (36) and the Left Crossbar Bracket (not shown).
Place one foot on the base in the indicated location.
Tip the treadmill back slightly.While the treadmill is held in this position, a second person should slide the
Stabilizer Plate (81) onto the base (see the lower inset drawing). Keeping your foot on the base, carefully tip the treadmill up until it is resting on the base. Make sure that the Stabilizer Plate (81) stays on the base.
Attach the Stabilizer Plate (81) to the base with a
Stabilizer Plate Bolt (91), two Stabilizer Plate Washers (94), and the Stabilizer Plate Nut (89) as shown.
7.Refer to assembly drawing 5 at the top of this page. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, lift the storage latch. Pivot the treadmill slightly until the locking pin is out of the stor- age latch.
Hold the treadmill firmly with both hands, and iower the treadmill to the floor. To decrease the possibility of In-
Jury, bend your legs and keep your back stralght.
Storage Latc_
6
36
89 If
7
8. Remove the paper backing from the Wrench Clip (28). | 8 | |
Press the Wrench Clip ontothe Frame (49) in the indi- | ||
| ||
cated location. Press the Allen Wrench (83) into the |
| |
Wrench Clip. | 26_ | |
|
6"