ProForm PCTL12009.0 user manual

Page 4


20.	Never leave the treadmill unattended while it	24. Inspect and properly tighten all parts of the
	is running. Always remove the key, unplug	treadmill regularly.
	cuit breaker to the off position when the	25. DANGER: Always unplug the power
	the power cord, and switch the reset/off cir-	cord immediately after use, before cleaning the
	treadmill is not in use. (See the drawing on	cord immediately after use, before cleaning the
	page 5 for the location of the circuit breaker.)	treadmill, and before performing the mainte-
21. Do not attempt to raise, lower, or move the		nance and adjustment procedures described in
21. Do not attempt to raise, lower, or move the		this manual. Never remove the motor hood un-
	treadmill until it is properly assembled. (See	less instructed to do so by an authorized ser-
	ASSEMBLY on page 6, and HOW TO FOLD	vice representative. Servicing other than the
	AND MOVE THE TREADMILL on page 20.)	procedures in this manual should be performed
	You must be able to safely lift 45 lbs. (20 kg)	by an authorized service representative only.
	to raise, lower, or move the treadmill.	26. This treadmill is intended for in-home use
22. When folding or moving the treadmill, make		only. Do not use this treadmill in a commer-
	sure that the storage latch is holding the	cial, rental, or institutional setting.
	frame securely in the storage position.	27. Over exercising may result in serious injury
23. Never insert any object into any opening on		or death. If you feel faint or if you experience
	the treadmill.	pain while exercising, stop immediately and
		cool down.
	SAVE THESE INSTRUCTIONS

4

Image 4

Contents Model No. PCTL12009.0 Serial No QUESTIONS?Contact OUR Customer SER- Vice Department Directly Table of Contents Important Precautions Various factors, including the users movePage Before YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedOvertighten the Nut the Wheels must turn Freely Bolts touch the Base do not fully tighten Patch Bolts yet Pinch the Wire Harness 84. Partially tightenNot fully fold the Frame yet Touch the Base do not fully tighten the Patch Bolts yet Bolts 3 do not tighten the Bolts yetInset drawing. The connectors should slide Ful not to pinch the wiresFirmly tighten the four 5/16 x 2 1/2 Patch Bolts Together easily and snap into place. If they doBe careful not to pinch the wires in the Right Handrail Be careful not to pinch the wires. Reattach HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleTurn on the fan if desired HOW to USE a Preset Workout Select one of the preset workouts. To select oneHOW to USE AN Ifit Workout Insert an iFit card and select a workoutInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Problem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PCTL12009.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PCTL12009.0 R0110A Exploded Drawing B-Model No. PCTL12009.0 R0110A Exploded Drawing C-Model No. PCTL12009.0 R0110A Exploded Drawing D-Model No. PCTL12009.0 R0110A Ordering Replacement Parts Limited Warranty