ProForm 760 user manual HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 23

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and the frame and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. Never move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Latch Knob

Frame

Handrail

Wheels Base

23

Image 23
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL79707.0 Serial No Table of Contents Important Precautions Page Before YOU Begin Hardware may be included AssemblySee the inset drawing. Tie the long tie Make sure that the power cord is unpluggedDo not fully fold the Frame yet Tighten the Nut the Wheel must turn freelyNot fully tighten the Bolts yet Be careful not to pinch the Upright WireFirmly tighten the Bolts Screws before tightening any of them Pull on the sleeve to make sure that it is locked into place PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console Console DiagramInsert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Select the manual modeChange the incline of the treadmill as desired Turn on the fan if desired Measure your heart rate if desiredPress the Quick Start button to start the work- out HOW to USE a Cross Training WorkoutSelect a cross training workout Continue the cross trainer workout Select a classic aerobic workout HOW to USE a Classic Aerobic Workout Complete the workout. See steps 4-9 on Select the monthly challenge Get a monthly challenge goal Start the workoutInformation Mode HOW to Review Your Monthly Challenge LOGOptional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Page Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description R0408AQty Exploded Drawing A-Model No. PFTL79707.0 R0408A Exploded Drawing B-Model No. PFTL79707.0 R0408A Exploded Drawing C-Model No. PFTL79707.0 R0408A Exploded Drawing D-Model No. PFTL79707.0 R0408A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty