ProForm 760 user manual Firmly tighten the Bolts

7. Press a Front Handrail Endcap (97) into the Left	7
Handrail (35). Attach the Front Handrail Endcap
with a #8 x 3/4" Handrail Screw (15).
Press an Upright Insert (110) into the Left				97
Upright (74). Set the Left Handrail (35) on the
Upright Insert.			15
Attach the Left Handrail (35) with two 3/8" x 1
1/4" Bolts (7) and two 3/8" Star Washers (9).
Firmly tighten the Bolts.		35
			110
			9
			7
		74
8. Hold the Right Handrail (33) near the Right	8
Upright (78). Insert the Upright Wire (38)
				97
through an Upright Insert (110), into the hole in		15
the bottom of the Right Handrail (33), and out of		Large Hole
the large hole in the side of the Right Handrail.		38
Insert the included plastic tie through the holes
in the Right Handrail (33) as shown. Look inside		Plastic Tie
the Right Handrail. Make sure that the plastic	7
tie holds the Upright Wire (38) to the side as		9
shown in the inset drawing. Tighten the plas-			Hole
tic tie.				Tie
		110	33
Press a Front Handrail Endcap (97) into the				38
Right Handrail (33). Attach the Front Handrail
		33
Endcap with a #8 x 3/4" Handrail Screw (15).
		78
Attach the Right Handrail (33) with two 3/8" x				110
1 1/4" Bolts (7) and two 3/8" Star Washers (9).			Hole
Firmly tighten the Bolts.
9. Set the Console Base (93) face down on a soft	9
surface to avoid scratching the Console.
Remove the two indicated screws (A) from the
Pulse Bar Bottom (95). Discard the screws.		A
	95
			93
	9